Differences between revisions 19 and 20
⇤ ← Revision 19 as of 2020-08-20 17:53:04 →
Size: 3297
Editor: naoki.koyama
Comment:
← Revision 20 as of 2020-08-20 17:54:35 → ⇥
Size: 3291
Editor: naoki.koyama
Comment:
Deletions are marked like this. Additions are marked like this.
Line 78: Line 78:
 *Allows you to choose which DoF to run.  *you can choose which DoF to run.

Log of Kamioka Activity during 2020/08/17 ~ 27

Participants

  • Koyama
  • Hirose
  • Yuzurihara
  • Kokeyama

Perpose

  • If you are unfamiliar with the simulation operations, there is a possibility that errors may occur in the script description and so on.
  • By creating a GUI, such errors can be prevented and the reliability of the simulation results can be increased.

Log (trial to use `eel`)

1. Installation of eel

note that:

* We installed several tools to run simulations using Finesse.

* We initially considered using eel, but found it difficult to create gui using eel and finesse at the same time, so we decided to use pysimplegui instead of eel.

* This eliminates the need to install eel (and chromium).

* PySimpleGUI is a module for python that creates gui.

eel is a Python module used to create a GUI.

I didn't found any instructions on how to install eel without using pip.

Therefore, we use pip to install eel in conda's virtual environment.

Activate the conda virtual environment. 

% conda activate XXXXX

And type the following command 

% pip install eel

To use eel, you need to install a specific browser like "chromium".

  • How to install chromium

You can install chromium by typing the following command. 

% sudo apt install -y chromium

2. Learning HTML and javascript

  • HTML and javascript are used to write scripts to create the GUI in eel

3. Learning Python

  • Python is used to run simulations using "finesse2
  • Creation of GUI In "finesse2", we use character strings which describe the simulation settings.
  • Create a selection box (GUI) and load the settings you entered into the box by "finesse2" and execute it.

4. Creating a simple GUI with python and HTML.

  • An error occurs when sending the input value to Finesse, so we are looking for an improvement.
  • We gave up to use eel.

Log (trial to use `PySimpleGUI`)

  • how we installed this package?
  • what is the name of virtual environment on control workstation?
    • MIFsim37
  • overplot ga mondai.We can't split plots.
  • pd1 ga hituyoukadouka ("Transfer function" uses "pd2". need "pd1" for "diff"?)
  • you can choose which DoF to run.
  • You can now choose where to put the PD.
  • You can now choose the laser power.
  • You can select a range for sweeping the mirror by entering a number. (Can't input other character. only numbers are allowed.)

Useful page

KAGRA/Subgroups/MIF/Simulation/KamikokaActivity20200817 (last edited 2020-10-18 17:32:36 by naoki.koyama)