= Installation Procedure for Type-Bp suspensions =
<<TableOfContents(3)>>

== Preparation at the NAOJ ==
 * Pre-assembly of the payload parts (RM, IM, IMRM)
  * [[http://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=3907|IM assembly procedure]]
 * Assembly and shipping of the bottom filters
 * Assembly and shipping of the traversers
 * Attachment of the magnets on the mirrors

== Preparation at Akeno ==
 * Send standard filters and earthquake stops from Akeno to Kamioka

== Out sourced works ==
 * Installation of the bottom plates
 * Installation of the inner frame
 * Installation of the bread boards including bread board dampers.  -> '''TO DO''': buy wires, damping magnets, hooks, springs, etc

== Installation at Kamioka ==
 * Preparation
  * Clean up the work area
  * Make sure all the necessary components are there
 * Set up the mirror assembly frame -> '''TO DO''': prepare a table to do this
 * Suspend the mirror & RM from the IM
  * [[http://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=3830|Mirror Hanging Procedure]]
 * Set up the suspension assembly frame -> '''TO DO''': prepare the assembly frame
 * Put the mirror+RM+IM into the assembly frame
 * Put a bottom filter and a standard filter