Diff for "KAGRA/Subgroups/VIS/OpsManual/FishingRods"

Differences between revisions 102 and 103

This page describes the status of the fishing rods and provides characterization information measured at the time of assembly.

It's important to bear in mind that the reported range of the stepper motor in number of steps is not expected to be accurate and it's useful only as a guideline:

Whenever the stepper driver is reset the posion of the motor (measured in number of steps from a zero) is lost and begins counting from zero wherever its physical position is.
Inaccuracies may arise when a stepper motor reaches the physical end of range because the driver still considers valid the requested position even when its beyond the physcal limit.

With respecto to the LVDT range limits, those may change with temperature.

Suspension	Stage	Available	Polarity (+steps)	Range	Others
ITMX	F0	Stacked[?]	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F1	OK [1]	Up [1]	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F2	OK [1]	Down [1]	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F3	NO [1]	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	BF	Stacked[?]	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
ETMX	F0	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F1	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F2	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F3	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	BF	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
ITMY	F0	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F1	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F2	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F3	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	BF	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
ETMY	F0	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F1	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F2	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	F3	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
	BF	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
Suspension	Stage	Available	Polarity (+steps)	Range	Others
BS	F0	?	?	LVDT : (-2500,+4900) um [2] Stepper : (-1.4e6, +1.4e6 ) steps [2]
	F1	?	?	LVDT : ( -700 , +700 ) µm [3] Stepper : ( -870,000 , +835,000 ) steps [3]
	BF	?	?	LVDT : ( -1000 , +1800 ) µm [4] Stepper : ( -746,000 , +746,000 ) steps [4]
SRM	F0	?	?	LVDT: : ( -865 , +626 ) µm [7] Stepper : ( -1.6e6 , +1.6e6 ) steps [7]
	F1	?	?	LVDT: : ( -1700 , +1400 ) µm [8] Stepper : ( -7e5 , +1.1e6 ) steps [8]
	BF	?	?	LVDT: : ( -3000 , +2800 ) µm [9] Stepper : ( -6e5 , +8e5 ) steps [9]
SR2	F0	?	?	LVDT: : ( -990 , 903 ) µm [5] Stepper : ( -1,700,000 , 1,500,000 ) steps [5]
	F1	?	?	LVDT : ( -750 , 1000 ) µm [6] Stepper : ( 300,000 , 1,000,00 ) steps [6]
	BF	?	?	LVDT: : ( -500 , +600 ) µm [10] Stepper : [ -5.5e5 , -2.5e5 ] steps [10]
SR3	F0	?	?	LVDT: : ( +885 , -1299 ) µm [11] Stepper : ( -5e5 , +1.1e6 ) steps [11]
	F1	?	?	LVDT: : ( -2000 , +2000 ) µm [12] Stepper : ( -7e5 , +1.1e6 ) steps [12]
	BF	?	?	LVDT: : ( -1600 , +1000 ) µm [13] Stepper : ( -2e5 , +2.5e5 ) steps [13]
Suspension	Stage	Available	Polarity (+steps)	Range	Others
PRM	SF	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
PRM	BF	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
PR2	SF	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
PR2	BF	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
PR3	SF	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []
PR3	BF	?	?	LVDT: : ( , ) µm [] Stepper : ( , ) steps []

References

[1] 14820
[2] 7694
[3] 3558
[4] 3280
[5] 8082
[6] 4431
[7] 7857
[8] 4721
[9] 4721
[10] 4430
[11] 7758
[12] 4720
[13] 4654
[] http://klog.icrr.u-tokyo.ac.jp/osl/?r=
[] http://klog.icrr.u-tokyo.ac.jp/osl/?r=
[] http://klog.icrr.u-tokyo.ac.jp/osl/?r=
[] http://klog.icrr.u-tokyo.ac.jp/osl/?r=
[] http://klog.icrr.u-tokyo.ac.jp/osl/?r=
[] http://klog.icrr.u-tokyo.ac.jp/osl/?r=
[] http://klog.icrr.u-tokyo.ac.jp/osl/?r=
[] http://klog.icrr.u-tokyo.ac.jp/osl/?r=
[] http://klog.icrr.u-tokyo.ac.jp/osl/?r=

Contents

Beam splitter
SR2
SR3
SRM

Beam splitter

Top filter

Range:
- LVDT: [ -2500 , +4900 ] µm (7694).
- Stepper motor: [ -1,400,000 , +1,400,000 ] steps (7694).
- Temperature when measured:
Observations:
- At 25 ºC it was possible to use the fishing rod to set the keystone at nominal position (8125).
- at 24.5 ºC or colder it was not (8645, 11465).

Standard Filter

Range:
- LVDT: [ -700 , +700 ] µm (7738, 3358).
- Stepper motor: [ -870,000 to +835,000 ] steps (7738, 3358).
- Temperature when measured:
Observations:
- It's been at its lowest position since the temperature was 25 ºC (8125, 8645).
- We set the keystone to 488 µm and couldn't move it further down (8125, 8645).

Bottom filter

Range:
- LVDT: [ -1000 µm , +1800 ] µm (3280).
- Stepper motor: [ -746,000 , +746,000 ] steps (3280).
- Temperature when measured:
Observations: this fishing rod doesn't seem to have any problems, but we haven't used it at every temperature condition we've had.

SR2

Top filter

Range:
- LVDT: [ -990 , 903 ] µm (8082).
- Stepper motor: [ -1,700,000 , 1,500,000 ] steps (8082).
- Temperature when measured:
Observations: This fishing rod is not known to have problems. See klog entry 13930.

Stardard filter

Range:
- LVDT: [ -750 , 1000 ] µm (4431).
- Stepper motor: [ 300,000 , 1,000,00 ] steps (4431).
- Temperature when measured:
Observations: This fishing rod is not known to have problems. See klog entry 13930.

Bottom filter

Range:
- LVDT: [ -500 , 600 ] µm (4430).
- Stepper motor: [ -550,000 , -250,000 ] steps (4430).
- Temperature when measured:
Observations: This fishing rod is not known to have problems.

Other related entries

Calculated temperature correction: 8082.
Recovery after pump down: 8160.

SR3

Top filter

Range:
- LVDT: [ 885 , -1299 ] µm (7758).
- Stepper motor: [ -500,000 , 1,100,000 ] steps (7758).
- Temperature when measured:
Observations: This fishing rod doesn't seem to have any problems (8135, 8658, 14890) (The previouly reported status was wrong: "After pump down it was not possible to move the keystone to zero using the fishing rod. It went as high as -750 µm at the time". However, I didn't find any klog reporting a problem with this fishing rod.)

Standard Flter

Range:
- LVDT: [ -2000 , 2000 ] µm (4720).
- Stepper motor: [ -700,000 , 1,100,000 ] steps (4720).
- Temperature when measured:
Observations:This fishing rod of not working at all (8135). It's a real shame because it had a large range of 4 mm total.

Bottom Filter

Range:
- LVDT: [ -1600 , +1000 ] µm (4654).
- Stepper motor: [ -200,000 , 250,000 ] steps (4654).
- Temperature when measured:
Observations:
- After pump down it was not possible to move the keystone to zero using the fishing rod. It went as high as -265 µm at the time 8658.
- The number of steps for the stepper motor seem relatively small. In principle there's nothing wrong with this but let's point this out.

Other related entries

8658, 8135.

SRM

Top Filter

Range:
- LVDT: [ -865 , 626 ] µm (7857).
- Stepper motor: [ -1,600,000 , 1,600,00 ] steps (7857).
- Temperature when measured:
Observations: This fishing rod is not known to have problems.

Standard Filter

Range:
- LVDT: [ -1,700 , 1,400 ] µm (4721) .
- Stepper motor: [ -700,000 , 1,100,000 ] steps (4721) .
- Temperature when measured:
Observations: This fishing rod is not known to have problems.

Bottom Filter

Range:
- LVDT: [ -3,000 , 2,800 ] µm (4721).
- Stepper motor: [ -600,000 , 800,000 ] steps (4721).
- Temperature when measured:
Observations: This fishing rod is not known to have problems.

Related entries

Recovery after pump down: 8197.

KAGRA/Subgroups/VIS/OpsManual/FishingRods (last edited 2020-09-18 10:45:40 by fabian.arellano)

-  ⇤ ← Revision 102 as of 2020-09-18 10:44:04 → 
  Size: 12822
  Editor: fabian.arellano
  Comment:
+   ← Revision 103 as of 2020-09-18 10:45:40 → ⇥
  Size: 12822
  Editor: fabian.arellano
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 93:
-  * '''LVDT:''' [ -700 , +700 ] µm ([[http://klog.icrr.u-tokyo.ac.jp/osl/?r=7738|7738]], [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=3358|3558]]).
  * '''Stepper motor:'''  [ -870,000 to +835,000 ] steps ([[http://klog.icrr.u-tokyo.ac.jp/osl/?r=7738|7738]], [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=3358|3558]]).
+  * '''LVDT:''' [ -700 , +700 ] µm ([[http://klog.icrr.u-tokyo.ac.jp/osl/?r=7738|7738]], [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=3358|3358]]).
  * '''Stepper motor:'''  [ -870,000 to +835,000 ] steps ([[http://klog.icrr.u-tokyo.ac.jp/osl/?r=7738|7738]], [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=3358|3358]]).