Differences between revisions 1 and 7 (spanning 6 versions)
⇤ ← Revision 1 as of 2017-02-26 16:58:33 →
Size: 301
Editor: MarkBarton
Comment:
← Revision 7 as of 2017-02-26 17:46:56 → ⇥
Size: 989
Editor: MarkBarton
Comment:
Deletions are marked like this. Additions are marked like this.
Line 3: Line 3:
[[../|Back to Operation Manual main page]]
Line 4: Line 6:

[[attachment:Add NPort.png|{{attachment:Add NPort.png||width=400}}]]

[[attachment:NPort Administrator-Configuration.png|{{attachment:NPort Administrator-Configuration.png||width=600}}]]

[[attachment:NPort Web Console ‎- Serial Settings.png|{{attachment:NPort Web Console ‎- Serial Settings.png||width=600}}]]

[[attachment:NPort Web Console ‎- Welcome.png|{{attachment:NPort Web Console ‎- Welcome.png||width=600}}]]

[[attachment:Options.png|{{attachment:Options.png||width=300}}]]

[[attachment:TMCL_PC Integrated Development Environment.png|{{attachment:TMCL_PC Integrated Development Environment.png||width=600}}]]

KAGRA VIS Operations Manual - Setup and Use of Stepper Motor Drivers

Back to Operation Manual main page

The stepper motor chassis designed by Kamiizumi-san has a TMCM-6110 driver card and a NPort® 5150A serial-Internet interface. See D1605365.

attachment:Add NPort.png

attachment:NPort Administrator-Configuration.png

attachment:NPort Web Console ‎- Serial Settings.png

attachment:NPort Web Console ‎- Welcome.png

attachment:Options.png

attachment:TMCL_PC Integrated Development Environment.png

KAGRA/Subgroups/VIS/OpsManual/Stepper (last edited 2019-01-07 14:54:47 by EnzoTapia)