Differences between revisions 7 and 8
⇤ ← Revision 7 as of 2017-02-26 17:46:56 →
Size: 989
Editor: MarkBarton
Comment:
← Revision 8 as of 2017-02-26 17:53:37 → ⇥
Size: 989
Editor: MarkBarton
Comment:
Deletions are marked like this. Additions are marked like this.
Line 7: Line 7:
[[attachment:Add NPort.png|{{attachment:Add NPort.png||width=400}}]] [[attachment:NPort Web Console ‎- Welcome.png|{{attachment:NPort Web Console ‎- Welcome.png||width=600}}]]
Line 13: Line 13:
[[attachment:NPort Web Console ‎- Welcome.png|{{attachment:NPort Web Console ‎- Welcome.png||width=600}}]] [[attachment:Add NPort.png|{{attachment:Add NPort.png||width=400}}]]

[[attachment:TMCL_PC Integrated Development Environment.png|{{attachment:TMCL_PC Integrated Development Environment.png||width=600}}]]
Line 16: Line 18:

[[attachment:TMCL_PC Integrated Development Environment.png|{{attachment:TMCL_PC Integrated Development Environment.png||width=600}}]]

KAGRA VIS Operations Manual - Setup and Use of Stepper Motor Drivers

Back to Operation Manual main page

The stepper motor chassis designed by Kamiizumi-san has a TMCM-6110 driver card and a NPort® 5150A serial-Internet interface. See D1605365.

attachment:NPort Web Console ‎- Welcome.png

attachment:NPort Administrator-Configuration.png

attachment:NPort Web Console ‎- Serial Settings.png

attachment:Add NPort.png

attachment:TMCL_PC Integrated Development Environment.png

attachment:Options.png

KAGRA/Subgroups/VIS/OpsManual/Stepper (last edited 2019-01-07 14:54:47 by EnzoTapia)