Differences between revisions 5 and 6
Revision 5 as of 2020-05-11 11:10:15
Size: 1536
Comment:
Revision 6 as of 2020-05-11 11:11:25
Size: 1565
Comment:
Deletions are marked like this. Additions are marked like this.
Line 9: Line 9:
 * --(Anatomy of OSEMs.)--  * --(Brief description of the anatomy of the OSEMs.)--

Describe KAGRA/Subgroups/VIS/TypeB/PaperTODOlist here.

Introduction

The mechanical system

Sensors and actuators for control

Introductory paragraph.

OSEMs

  • Brief description of the anatomy of the OSEMs.

  • Typical OSEM sensitivity measured when locking the target.

  • Typical measuring range according to all the units used in BS, SR2, SR3 and SRM.

  • Typical calibration value. (Fabian, klog 4189.)
  • Produce a nicer plot (Fabian).
  • Write the figure caption (Fabian).
  • Write a couple of sentences about the coil-magnet actuator and cite Mark’s document and Michimura-san’s paper. (Mark.)

LVDTs

Optical lever

  • Brief description of the oplev.

  • Brief description of diagonalization procedure.

  • Where the displacement calibration comes from: relativeposition of components measured with ruler, dimensions given by the 3D-CAD, QPD displacement calibration and comparison with IP displacement.

  • Typical extent of coupling after diagonalization.

  • Typical measuring range.

  • Write the diameter of the beam determines the linear range of the QPD as a beam displacement sensor. (Fabian.)
  • Point out that the oplev is expected to be limited by the seismic motion. (Fabian.)
  • Say it is not easy to measure directly the oplev sensitivity but it is possible to set an upper limit to the optic rms displacement and velocities. (Fabian.)

Geophones

Control and performance

What we have

What we aim for

KAGRA/Subgroups/VIS/TypeB/PaperTODOlist (last edited 2020-06-15 13:07:43 by fabian.arellano)