|
Size: 1565
Comment:
|
Size: 1689
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 28: | Line 28: |
| === Geophones === | === Inertial sensors === * Brief description of what a geophone is. * Brief explanation of the Calculated nooise budget of the geophone |
Describe KAGRA/Subgroups/VIS/TypeB/PaperTODOlist here.
Introduction
The mechanical system
Sensors and actuators for control
Introductory paragraph.
OSEMs
Brief description of the anatomy of the OSEMs.
Typical OSEM sensitivity measured when locking the target.
Typical measuring range according to all the units used in BS, SR2, SR3 and SRM.
- Typical calibration value. (Fabian, klog 4189.)
- Produce a nicer plot (Fabian).
- Write the figure caption (Fabian).
- Write a couple of sentences about the coil-magnet actuator and cite Mark’s document and Michimura-san’s paper. (Mark.)
LVDTs
Optical lever
Brief description of the oplev.
Brief description of diagonalization procedure.
Where the displacement calibration comes from: relativeposition of components measured with ruler, dimensions given by the 3D-CAD, QPD displacement calibration and comparison with IP displacement.
Typical extent of coupling after diagonalization.
Typical measuring range.
- Write the diameter of the beam determines the linear range of the QPD as a beam displacement sensor. (Fabian.)
- Point out that the oplev is expected to be limited by the seismic motion. (Fabian.)
- Say it is not easy to measure directly the oplev sensitivity but it is possible to set an upper limit to the optic rms displacement and velocities. (Fabian.)
Inertial sensors
- Brief description of what a geophone is.
- Brief explanation of the Calculated nooise budget of the geophone
Control and performance
What we have
What we aim for