= 20180130 =
[[http://klog.icrr.u-tokyo.ac.jp/osl/?r=4056]]
== Today's activities ==
Workers: Akutsu, Simon, Miyo, Hasegawa
 * Attached the protectors again.
 * Aattached again the oplev reflectors.
 * Attached heaters.
 * Attached 4 out of 6 thermometers temporally ('''''without the metal sheets!!!''''').
  * Note: each thermometer has its own serial number to distinguish oneself from the others.
 * Set up the oplev.
  * For this purpose an oplev viewport was installed in -Y+X direction at the TM level (Hasegawa).
 * Detached the protectors to see how the suspended WAB got tilted.
   * '''''Simon's memo...'''''
 * Attached a heat link partly, after the protectors were attached again.
 * Helped cabling to the digital system (Miyo).
 * '''[Ongoing]''' Need cares of water springs from anchor bolts for oplev pylons.
 * '''[Ongoing]''' Need to confirm what are the scratch lines made by the measurement by the KEK team last week.

== Next plan ==
 * Learn how to attach pins to electric cables of the thermometers (AWG36).
 * '''''Set up oplev to check how the damping would be now after the replacement of the damping magnets.'''''
 * Check the reproducibility of the alignment of the suspension among several modes.  
 * Try to connect burndy pins to the heaters??
 * Check heights of several points.
 * Wash the coil in ethanol at Univ. of Toyama...?
 * Take care of water spring??

== Wanted! ==
 * '''''Stages outside the chamber''''' to ease wiping our legs.
 * Good '''''rail(?)''''' to move the WAB suspension in the cryostat in the main beam direction.
 * '''''Chain block?''''' to support the load in the chamber.
 * Cutters and scissors!!
 * A clock to know the time easily.
 * A fiber cleaner to connect oplev source parts; '''''need to get back''''' from Yend.
 * M6 screw set.