= Check if the real time models are sending data to DAQ =

== DC status on each mode's GDS_TP screen should be 0x0. ==

=== 1. Open sitemap on an workstation ===
{{{
$sc
$medm sitemap.adl
}}}
[[attachment:sitemap.png|{{attachment:sitemap.png|text describing image|width=300}}]]

=== 2. Open CDS screen ===

[[attachment:cdsscreen.png|{{attachment:cdsscreen.png|text describing image|width=300}}]]

 
=== 3. Open GDS_TP screen of each model (blue buttons) ===

=== 4. Check that "DC Status" is 0x0 ===

[[attachment:gdstp.png|{{attachment:gdstp.png|text describing image|width=300}}]]

|| DC status || What to do ||
|| 0x0 || Good status! ||
|| x4000|| It is OK. Data is being sent and you can leave it. There is some synchronization error. ||
|| x2000|| It is OK. Data is being sent and you can leave it. There is some synchronization error.||
|| 0x2bad || Bad. The real time model is not sending data to the data concentrator machine, k1dc0. Go to (1) ||
|| blank || Bad. Channels are not registered to send to k1dc0. Go to (2) ||
 
=== When DC status is blank ===
==== 1. First check ====
make sure the model's channel list is registered in {{{master}}}.
{{{
t
cd fb
emacs master
}}}
Check if
 1. tpchn_modelname.par
 1. MODELNAME.ini
are written in the file. 

==== 2. If master is ok, but still blank, or, if you changed master file ====

''' Before doing this, let everyone know that DQ will be killed '''
{{{
ssh k1dc0
ps -ef | grep daqd }}}
Check the process number of daqd. There may be two or three and pick the first and left number (###).
{{{
kill ###}}}
{{{daqd}}} process will automatically start up again, and the DAC status will be cleared.

==== 3. If neither above did not work ====
Reboot the data concentrator:
{{{
ssh k1dc0
sudo reboot}}}
Wait patiently until {{{k1dc0}}} restarts.

==== 4. Rebooting did not work ====
Call Osamu or Keiko.