|
Size: 1573
Comment:
|
Size: 1658
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 19: | Line 19: |
| * | |
| Line 22: | Line 22: |
| * LSC full model has been implemented in k1imc. | * LSC full model has been implemented in k1imc0. * CAL model is being tested on k1imc0. * Cal line will be produced in CAL model. |
Minute of KAGRA commissioning meeting
- Date: 2018/3/20 11AM~12PM
- Attendance: Miyakawa, Aso, Yokozawa, Izumi, Akutsu
- eZuce: Ushiba, Suzuki, Tomaru, Inoue
1. Report of work of the last week and plan of work
- Alignment, ETMY: Izumi
- Tuning of ETMY is still going on. Currently RMS is ~10urad.
- ETMY yaw motion is still large.
- Length, Yaw, Translation (diagonal of L) of BF dampings are not easy.
- Only Yaw seems to be damped, but combination of them is not going well.
- Beam will be checked every night, specially after pump down yesterday.
- IMMT1,2 shifted in pitch by ~200urad, in yaw by ~100urad.
- Tuning of ETMY is still going on. Currently RMS is ~10urad.
- MIF:
- LSC full model has been implemented in k1imc0.
- CAL model is being tested on k1imc0.
- Cal line will be produced in CAL model.
- CAL:
- Started using IMC as training of calibration.
- X end PD will be removed and Baffle PD will be located instead. Changing PD will be done around 3/26.
- Cryo:
- Current temperature is 18K.
2. Schedule of ETMX installtion
- See the schedule at the commissioning top page.
3. Tasks or discussions
- CAL model location? at the same k1imc, or k1test with Dolphin connection.
Selection of storing DAQ channel -> DGS, before phase 1
- Check the total amount.
Screens at control room -> who, when?
- Needs laser safety information.
GW alert: online alert in the control room might be prepared. -> Togoshi
4. Phase2
Others
- Frequency noise can be measured by middle lock. Large intensity noise can be a problem.
- Next meeting: 3/27