Differences between revisions 8 and 13 (spanning 5 versions)

Minute of KAGRA commissioning meeting

Date: 2018/4/3 11AM~12PM
Attendance: Uchiyama, Kokeyama, Yokozawa, Aso, Izumi
- eZuce: Miyakawa, Yamamoto(Kazuhiro), Suzuki, Hirose, Yamamoto, Inoue, Ushiba, Shoda, Kimura

1. Report of work of the last week and plan of work

IFO: Izumi
- Beam from both X and Y end was confirmed at REFL port.
ETMs: Ushiba
- ETMY damping mirror motion has been suppressed to ~1urad in yaw (Miyamoto).
- ETMX has no heat link and is characterized without heat link. Heat link is connected on Thursday.
RT model
- Cable connection is almost done.
- Dolphin should be connected as soon as possible. It can stop all models connected Delphin.
- BS model will be splitted and one of them will be down sampled to 4kHz.
Oplev: Ushiba
- Test mas calibration was done.
- Length oplev is not ready yet.
- Marionette Oplev will be calibrated when door closed.
CAL: Yamamoto, Yokozawa
- RT calibration using IMC as training of calibration will be tested soon.
- Off line calibration using FIR filter won't be used in phase 1.
DAQ
- k1tw0 is sometimes down as like other FWs.
- SSD will be tested soon.

KAGRA/Commissioning/Weekly/20180403/Minute (last edited 2018-04-03 12:05:59 by OsamuMiyakawa)

-  ⇤ ← Revision 8 as of 2018-04-03 11:14:28 → 
  Size: 1478
  Editor: OsamuMiyakawa
  Comment:
+   ← Revision 13 as of 2018-04-03 11:41:05 → ⇥
  Size: 1823
  Editor: OsamuMiyakawa
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 19:
- * Oplev:
+ * RT model
  * Cable connection is almost done.
  * Dolphin should be connected as soon as possible. It can stop all models connected Delphin.
  * BS model will be splitted and one of them will be down sampled to 4kHz.
-Line 21:
+Line 24:
+ * Oplev: Ushiba
  * Test mas calibration was done.
  * Length oplev is not ready yet.
  * Marionette Oplev will be calibrated when door closed.
-Line 23:
+Line 30:
-  * Started using IMC as training of calibration.
   * Simple calibration will be implemented.
  * X end PD is removed at 3/27 today.

 * RT model
+  * RT calibration using IMC as training of calibration will be tested soon.
  * Off line calibration using FIR filter won't be used in phase 1.
-Line 30:
+Line 34:
+  * k1tw0 is sometimes down as like other FWs.
  * SSD will be tested soon.
-Line 52:
+Line 59:
- * Frequency noise can be measured by middle lock. Large intensity noise can be a problem.