813
Comment:
|
← Revision 7 as of 2018-06-26 11:48:50 ⇥
1277
|
Deletions are marked like this. | Additions are marked like this. |
Line 5: | Line 5: |
* Attendance: Miyakawa, Aso, Yokozawa, Ohishi, Kokeyama, Miyoki, Tahara, Enomoto, Stefan, Tomura, Ushiyama, Nakano * eZuce: Ushiba, Izumi, Inoue, Yamamoto(Toyama), Suzuki, Hirose, Shoda |
* Attendance: Miyakawa, Yokozawa, Stefan, Nakano, Yamamoto * eZuce: Shoda, Ushiba, Hirose, Eleonora, Izumi, Yamamoto(Toyama), Kokeyama, Miyoki |
Line 8: | Line 8: |
== Topic == |
|
Line 13: | Line 11: |
* Two PZT steering mirrors were installed yesterday for input beam to IMC. * Calibration to Hz will be done today. * Thermal drive is sill missing. * Needs fitness, noise budget or something. * Probably we do not need to change HV PZT driver by O3, but needs estimation. |
|
Line 24: | Line 27: |
* ETMX and ITMX should be located at half low temperature stage and room temperature stage. It means that ~5mm off from the nominal position. Type A can compensate ~5mm. |
|
Line 25: | Line 30: |
* Cable cleaning on BS rack will be done this weekend. |
Minute of KAGRA commissioning meeting
- Date: 2018/6/26 11AM~12PM
- Attendance: Miyakawa, Yokozawa, Stefan, Nakano, Yamamoto
- eZuce: Shoda, Ushiba, Hirose, Eleonora, Izumi, Yamamoto(Toyama), Kokeyama, Miyoki
PMC
- Summary of PMC work by Stefan during his stay at KAGRA
- Two PZT steering mirrors were installed yesterday for input beam to IMC.
- Calibration to Hz will be done today.
- Thermal drive is sill missing.
- Needs fitness, noise budget or something.
- Probably we do not need to change HV PZT driver by O3, but needs estimation.
PMC servo modifications -> Stefan
FSS and PMC locked together -> Nakano, Stefan
PMC autolocking sped up -> Stefan, Nakano
Others
Beam height brain storming -> next week?
- ETMX and ITMX should be located at half low temperature stage and room temperature stage. It means that ~5mm off from the nominal position. Type A can compensate ~5mm.
Necessary number of High power coil driver -> Aso
- Cable cleaning on BS rack will be done this weekend.
- Next meeting: 7/3.