Differences between revisions 1 and 6 (spanning 5 versions)
Revision 1 as of 2021-04-08 15:40:14
Size: 187
Editor: YoichiAso
Comment:
Revision 6 as of 2021-04-12 13:33:25
Size: 2936
Editor: mie.ueda
Comment:
Deletions are marked like this. Additions are marked like this.
Line 5: Line 5:
== Interferometer related == == Main Interferometer related ==
Line 9: Line 9:
== Cryogenic related == == Cryogenics related ==
=== Thermal Noise ===
 * Mechanical Q measurement (sapphire fiber, blade spring, bonding, coatings, ...)
 * Evaluation of sapphire suspension thermal noise
 * Evaluation of thermal noise of integrated cryo-payload
 * Design of new sapphire blade spring
 * Measurement of violin mode of sapphire suspension fibers and their subtraction from data

=== Cryogenics ===
 * Development of high-sensitivity local displacement sensor at low temperature
 * Development of frosting removal on mirror by using CO2 laser or heater
 * Evaluation of low-magnetism black-coating (optical absorption at 1064nm ...)
 * Optical absorption measurement of sapphire mirror at low temperature
 * Development of non-contact temperature measurement method of mirror

== Physical Environment Monitoring related ==
=== Underground environment evaluation ===
 * New environmental monitors
 * Seismometer analysis
 * Magnetometer analysis
 * Microphone analysis
 * Newtonian noise evaluation

=== Interferometer noise evaluation ===
 * New environmental monitors
 * Power line monitor, GND survey
 * Correlation/coherent analysis (Close to commissioning)
 * Glitch, line noise evaluation (Close to DetChar)
 * Feedforward, offline noise subtraction
 * PEM injection test

== VIS(Vibration Isolation System)==
=== Sensor Development===
 * Development of new local sensor with high-sensitivity, wide-range and cryogenic use, replaced from OSEM and photo-sensor
 * Development of new local sensor by using optical comb technology
 * Development of inertial sensor (seismometer, accelerometer)

=== Performance Improvement ===
 * Optimization of control, development of active filter
 * Control of low frequency range by using GIF
 * Improvement of lower frequency performance of IP
 * Development of light and easy maintenance GAS filter


== Calibration related ==
=== DAC/CAL (Sftware) ===
 * Timing correction
 * Line-noise subtraction
 * Optimization of avoidance method of dynamic range problem
 * Improvement of self-diagnosis of pipe-line
 * Improvement of interface of pipe-line, filter, injection and so on

=== Commissioning/CAL (Hardware)===
 * PCAL
 * Higher performance of calibration of integrating sphere (5% -> <1%)
 * Mitigation of scattered light(in O4)
 * Stabilization of Pcal laser
 * Correction of temperature dependence of integrating sphere
 * Evaluation of integrating sphere like injection angle of laser and opening size (in O5)
 * Development of Gcal

== Data Management related ==

== Input & Output Optics related ==

== Laser related ==

== Auxiliary Optics related ==

== Digital System related ==

== Detector Characterization related ==

== Mirror related ==

Possible research topics for graduate students and postdocs

Thermal Noise

  • Mechanical Q measurement (sapphire fiber, blade spring, bonding, coatings, ...)
  • Evaluation of sapphire suspension thermal noise
  • Evaluation of thermal noise of integrated cryo-payload
  • Design of new sapphire blade spring
  • Measurement of violin mode of sapphire suspension fibers and their subtraction from data

Cryogenics

  • Development of high-sensitivity local displacement sensor at low temperature
  • Development of frosting removal on mirror by using CO2 laser or heater
  • Evaluation of low-magnetism black-coating (optical absorption at 1064nm ...)
  • Optical absorption measurement of sapphire mirror at low temperature
  • Development of non-contact temperature measurement method of mirror

Underground environment evaluation

  • New environmental monitors
  • Seismometer analysis
  • Magnetometer analysis
  • Microphone analysis
  • Newtonian noise evaluation

Interferometer noise evaluation

  • New environmental monitors
  • Power line monitor, GND survey
  • Correlation/coherent analysis (Close to commissioning)
  • Glitch, line noise evaluation (Close to DetChar)

  • Feedforward, offline noise subtraction
  • PEM injection test

== VIS(Vibration Isolation System)== === Sensor Development===

  • Development of new local sensor with high-sensitivity, wide-range and cryogenic use, replaced from OSEM and photo-sensor
  • Development of new local sensor by using optical comb technology
  • Development of inertial sensor (seismometer, accelerometer)

Performance Improvement

  • Optimization of control, development of active filter
  • Control of low frequency range by using GIF
  • Improvement of lower frequency performance of IP
  • Development of light and easy maintenance GAS filter

DAC/CAL (Sftware)

  • Timing correction
  • Line-noise subtraction
  • Optimization of avoidance method of dynamic range problem
  • Improvement of self-diagnosis of pipe-line
  • Improvement of interface of pipe-line, filter, injection and so on

=== Commissioning/CAL (Hardware)===

  • PCAL
  • Higher performance of calibration of integrating sphere (5% -> <1%)

  • Mitigation of scattered light(in O4)
  • Stabilization of Pcal laser
  • Correction of temperature dependence of integrating sphere
  • Evaluation of integrating sphere like injection angle of laser and opening size (in O5)
  • Development of Gcal

KAGRA/KSC/EducationTraining/ResearchTopics (last edited 2021-04-12 23:25:37 by terrence.tsang)