= 20180928 =
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=6342]]
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=6351]]
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=6352]]


== Today's activities ==
Workers: Akutsu, Uraguchi, K. Nagano, Hasegawa, K. Tanaka, Kita
 * Put tags to cables partially.
 * Confirmed all signals could be seen in digital system.
 * Confirmed vertical actuation coils worked well.
   * Although Nagano said "horizontal" coils were checked, it was wrong. It was found that cable of vertical and horizontal coils were flipped.
 * Delivered mirror (three 1-inch Green Steering mirrors) were put on the desiccator.
 * Installed BRT on TMS-VIS; see [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=6342|here]].
 * We confirmed Green beam was reduced by BRT properly. Also, we could see the shadow of PDA100A which was placed in front of ETMX.

== Next plan ==
 * Connect the cables to flanges.
 * Configure the digital models properly.
  * Engage the logical channels and the assigned physical channels.
 * Install BRT on TMS-VIS.
 * Clean the sides of the optics to be installed into the vacuum chamber. (Ethanol+Acetone wiping with vectra alpha, then First Contact.) See [[https://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=9015|here]].
 * Detach the remaining white tapes just before closing the chamber; be noted that there are white tapes on the PEEK connectors at the inside of the flanges.
 * Torque completely the bolts which are fixing the upper and the lower base plates.
 * Insert metal gaskets before torquing the ICF203 flanges with Dsub connectors.
 * Make clean the cabling... ask to VIS??

 * Check horizontal actuation
 * Calibrate LVDT again
 * Put calibration factor of Geophones
 * Install Tome-Kanagu for Dsub in DAC0 port #4
 * Put tags to cables
 * Align BRT
 * Start to install GPT part
 * Damping of TMS-VIS


== Wanted! ==
 * Tester!! lend from DGS or PEM??
 * M8 eyebolts for managing the dummy weight plates...
 * First contact to clean the side diameter of the optics.
 * Need a signal generator for LVDTs
 * A document for learning how to release or fix the suspended tables (by Uraguchi?).

 * Cable tags
 * IR mirrors (4 PYD-20, 3 PYD-10)
 * Tome-Kanagu for Dsub
 * Power taps
 * ONE DAC PORT!!!!