|
⇤ ← Revision 1 as of 2019-01-15 23:13:57
Size: 2679
Comment:
|
Size: 2092
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 20: | Line 20: |
| * --(Place/install the WAB suspension)-- * --(Align the position of WAB -> take WAB back to nominal position, put off protectors))-- * --(horizontal alignment)-- * --(yaw alignment)-- * --(Move it to the saving mode.)-- * --(Back to the nominal position.)-- * --(Attach heat links)-- * --(4 soft heat links to WAB)-- * --(1 heat link btwn the top and the structure)-- * --(Attach 2 thermometers)-- |
* Place/install the WAB suspension * Align the position of WAB -> take WAB back to nominal position, put off protectors) * horizontal alignment * yaw alignment * Move it to the saving mode. * Back to the nominal position. * Attach heat links * 4 soft heat links to WAB * 1 heat link btwn the top and the structure * Attach 2 thermometers |
| Line 35: | Line 35: |
| ||A||75 ohm|| Thermometer S/N#2564|| V- || Green || WAB || || ||B||75 ohm|| Thermometer S/N#2564|| V+ || Black || WAB || || ||C||4 ohm|| Thermometer S/N#2564|| I- || Red || WAB || || ||D||4 ohm|| Thermometer S/N#2564|| I+ || Yellow || WAB || || ||E||75 ohm|| Thermometer S/N#360|| V- || Green || Structure || || ||F||75 ohm|| Thermometer S/N#360|| V+ || Black || Structure || || ||G||4 ohm|| Thermometer S/N#360|| I- || Red || Structure || || ||H||4 ohm|| Thermometer S/N#360|| I+ || Yellow || Structure || || |
Wide Angle Baffle at EXC
|
|
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Links to knowledge
Calculations regarding the back-scattering of different Wide Angle Baffle designs (Zeidler)
Personal calc of WAB's stray light noise by Akutsu; due to several uncertain parameters there are several results and no one would know the actual effect!
Heat links positions (by Obuchi) fmkopgehpapgdkcc.png
Task list
Note: some of the tasks can be done in parallel.
- Place/install the WAB suspension
Align the position of WAB -> take WAB back to nominal position, put off protectors)
- horizontal alignment
- yaw alignment
- Move it to the saving mode.
- Back to the nominal position.
- Attach heat links
- 4 soft heat links to WAB
- 1 heat link btwn the top and the structure
- Attach 2 thermometers
- Set revised blocks under the base plate.
Pin Assignment
P23, to be connected to Cryocon#7 E and F in this order respectively.
Pin Name |
Resistance |
Equipment |
Assign |
Comment1 |
Comment2 |
Connection |
Note that the pin arrangement (or the naming) is mirrored compared with that of in IXC! Rather, I guess this IXC's would be correct.