|
Size: 2098
Comment:
|
Size: 2064
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 21: | Line 21: |
| * Align the position of WAB -> take WAB back to nominal position, put off protectors) * horizontal alignment * yaw alignment * Move it to the saving mode. |
* --(Align the position of WAB)-- * --(horizontal alignment)-- * --(yaw alignment)-- * --(Move it to the saving mode.)-- |
Wide Angle Baffle at EXC
|
|
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Links to knowledge
Calculations regarding the back-scattering of different Wide Angle Baffle designs (Zeidler)
Personal calc of WAB's stray light noise by Akutsu; due to several uncertain parameters there are several results and no one would know the actual effect!
Heat links positions (by Obuchi) fmkopgehpapgdkcc.png
Task list
Note: some of the tasks can be done in parallel.
Place/install the WAB suspension
Align the position of WAB
horizontal alignment
yaw alignment
Move it to the saving mode.
- Back to the nominal position.
- Attach heat links
- 4 soft heat links to WAB
- 1 heat link btwn the top and the structure
- Attach 2 thermometers
- Set revised blocks under the base plate.
Pin Assignment
P23, to be connected to Cryocon#7 E and F in this order respectively.
Pin Name |
Resistance |
Equipment |
Assign |
Comment1 |
Comment2 |
Connection |
Note that the pin arrangement (or the naming) is mirrored compared with that of in IXC! Rather, I guess this IXC's would be correct.