= 20180904 =
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=6011]]

== Today's activities ==
Workers: Akutsu, Simon, Yano, Ken Tanaka
 * Checked and adjusted the height
  * Firstly draw a reference line on a white tape attached to the wall of the 8K shield to easily check where is the center of duct; which was, as written in the klog above, 269mm from the top surface of the breadboard... the nominal number should be 270mm, right??
  * Anyway we continued the checking and found the suspended WAB was slightly rolling, so adjusted the roll by the top stages.

== Next plan ==
 * Check the height and horizontal position of the WAB.
 * Check the pitch and yaw of the WAB.
 * Before moving the WAB suspension to the saving mode, attach the magnet dampers.

== Wanted! ==
 * Vertical standing ruler (or Height Gauge)