Calibration Tasks and Milestones (Towards O3)

Goals

• Make the whole chain of h(t) reconstruction running with Pcal
  • 3 types of h(t) provide (online, low latency, offline)
  • online h(t) generation using Pcal(DGS)
  • low latency and offline will be similar code
• Accuracy at the initial LIGO O1 level (10%,10deg.)
  • LIGO also have many try and error
  • free sweging is used for calibration method comparison
  • final goal is 1%, 1deg.
• By the starting of phase-2 engineering run (well in advance of joining O3)

Task (Responsible and sub-responsible person(s))

• Cross out if the tasks are completed

Listing-up (S.Haino and responsible people)

• List-up tasks and responsible person(s)
• List-up milestones and deadline
• Submit the list of task and milestone to the KAGRA scheduler

Pcal (Y.Inoue, C.Kozakai, Cory, Bin-Hua)

• Install Pcal at X and Y-end and coordinate the long-term Pcal characterization

• Prepare for the necessary EPICS channels to the online system for the calibration

• List-up the systematic error budget table for O3
• Achieve 1% displacement error
• Absolute power calibration
  • Contact person of working standard of Toyama univ.
  • Absolute calibration organization
• Maintenance at Kamioka site.
• BH should stay Kamioka and periodic work
• Telephoto camera
  • Installation is almost done
  • Maintenance of TCam is done by T.Yokozawa
  • IR filter issue(spare camera), additional spare camera.
  • Image analysis by Tomigami.

Front-end (T.Yamamoto, +1person from off-site)

• Make the models for the online h(t) reconstruction
• Provide the necessary DAQ channels for the low-latency calibration
• ...

Low-latency and offline (D.Tuyenbayev, S.Tsuchida, S.Haino)

• Ask to LIGO CAL team for the detailed information of gstlal-calibration (DT)
• Make gstlal-calibration running on a machine at KAGRA (DT, SH)
• Use gstlal-calibration for the offline h(t) reconstruction of bKAGRA phase-1 data (ST, DT)
• Generation of FIR filters for KAGRA DARM model (ST, DT)
• Feed KAGRA online channels into gstlal-calibration and generate low-latency h(t) (ST, DT, SH)

DARM model (T.Yamamoto,..., D.Tuyenbayev)

• Make a subway map of the KAGRA DARM model
• Optimize the calibration lines
• Coordinate the Open Loop Gain (OLG) Transfer function measurements
• Estimate and trace the slow time variation of the calibration parameters
• Electronics transfer function.

Pcal verification (Y.Inoue,...)

• Coordinate h(t) calibration with the Free-swinging Michelson method
• Compare h(t)s calibrated between Free-swinging Michelson and Pcal
• Compare h(t)s calculated between diff,common,...

Hardware injection (T.Yokozawa, Cory, )

• Make the online model for the hardware injection with actuators
• Make the online model for the hardware injection with Pcal
• Coordinate the hardware injection tests
• Analyze the hardware injected data and verify the DARM subway map

Systematic errors assignment (T.Sawada, Y.Inoue, S.Haino)

• Estimate the systematic errors due to calibration
• Make a simulation.
• Provide the number (amplitude and phase) for the data analysis group
• Provide the calibration envelopes for the data analysis group
• (If possible) Incorporate DARM model and parameter uncertainties in the data analysis