|
Size: 2046
Comment:
|
Size: 2142
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 19: | Line 19: |
| * K1:CAL-CS_PROC_XARM_FREQUENCY_DQ | * (1) K1:CAL-CS_PROC_XARM_FREQUENCY_DQ |
| Line 22: | Line 22: |
| * K1:CAL-CS_PROC_DARM_DISPLACEMENT_DQ * DARM displacement [nm or m] there are still some bugs in the online model, I will summarize later |
* (2) K1:CAL-CS_PROC_DARM_DISPLACEMENT_DQ * --(DARM displacement [nm or m] there are still some bugs in the online model, I will summarize later)-- Fixed(Due to the fail of the filter) * (3) K1:CAL-CS_PROC_MICH_DISPLACEMENT_DQ |
Summary of the morning run
Time (JST) |
Time (GPS) |
IFO config |
Main channel |
klog |
Memo |
2019/08/27 02:09-09:26 |
1250874558 - 1250900778 |
Yarm cavity |
K1:CAL-CS_PROC_XARM_FREQUENCY_DQ |
Silent run |
|
2019/08/28 07:54-09:07 |
1250981658 - 1250986038 |
FPMI |
K1:CAL-CS_PROC_DARM_DISPLACEMENT_DQ |
Silent run |
|
2019/08/29 07:43-08:46 |
1251067398 - 1251071178 |
FPMI |
K1:CAL-CS_PROC_DARM_DISPLACEMENT_DQ (Some bug) |
Silent run |
|
2019/08/30 05:12-08:43 |
1251144738 - 1251157398 |
SRMI |
K1:CAL-CS_PROC_(MICH/SRCL)_DISPLACEMENT_DQ |
Silent run |
Note for beginner
- Time
- JST or GPS time
- IFO config = Interferometer configuration
- Yarm cavity : Lock the Yarm cavity by feedback to the IMC length (Almost frequency noise evaluated by Yarm length)
- FPMI : Fabry-Perot Michelson interferometer. The h-of-t signal is calculated from DARM displacement
- Main channel
- We should analyze this channel as h(t) channel
- (1) K1:CAL-CS_PROC_XARM_FREQUENCY_DQ
- Unit is Hz, because of calculating the IR laser frequency noise
- Even though Yarm lock, the channel name is XARM. The same strategy to keep the cavity.
- (2) K1:CAL-CS_PROC_DARM_DISPLACEMENT_DQ
DARM displacement [nm or m] there are still some bugs in the online model, I will summarize later Fixed(Due to the fail of the filter)
- (3) K1:CAL-CS_PROC_MICH_DISPLACEMENT_DQ
- klog
- Information related to the run is summarized here
- Memo
- What is this?
- In the future, we want to do the calibration line injection, PEM injection, add the excitation and check the noise, hardware injection, and so on.
- We will write following information.