= Monday Meeting 0115 =

== Participants ==
Kokeyama, Izumi, Nakano, Somiya, Uehara, Moriwaki, Matsushima, Yamamoto, Ono, Doi,Kanbara, Yokogawa, Kitazawa, Sakamoto, Yoshioka, Miyata, Sawada,

== Updates from projects ==
 * Those who still don't have the klog account should make contact to Raffaele of NAOJ via an email.
 * Somiya-san presented the status and plans for the OMC.
 
   * A critical point for now: they don't have an OSTM mirror in hand. There are two choices: one is to get a 2 inch mirror, the other is to get a substrate from the MIR group and get it polished. If we use a 6 cm thickness mirror from MIR, the thickness might be a problem although it shouldn't clip the beam in theory.

   * Wiring is not done at all at the moment.

   * the thickness of the aluminum breadboard is set such that the weight is identical to that for the silica breadboard.
 
   * LEX-ZERO has a small thermal expansion coefficient. Actually smaller than invar. Out gassing was measured by an outside company.
    
   * The range of the PZT should be large enough if the temperature swings within +/- 0.3 deg.
   
   * A wrong side of the bottom surface was polished for OBS1. This was fixed by polishing the correct side by an outside company.

   * OBS3 needs to be out when adjusting the angle of OMC2 by a micrometer.

   * RF DARM will be extracted from the diode in transmission of OSTM. Also, WFSs are from the same place.

   * The suspension cage can have actuators, but currently they are not planning to attach the actuators.

   * If the aluminum OMC is good enough, it can stay as a final component in chamber, as opposed to the silica one.

   * No QPD will be placed behind OMMT1.

== Plan for this week ==
 * 1/16 Tue ISS work in Kamioka
 * 1/17-20 NiigataU Nogai-kun visit

== Topic of this week ==

[[https://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=7654|OMC report]] (Somiya)