Differences between revisions 15 and 16

Installation work 2018/10-11

It turned out that the Table B is to be moved to the SR2 area for ALS (10/11)
Miyoki-san suggested to use an uninterruptible power supply for the omc laser (10/12)
Akutsu-kun suggested to simply remove a blank flange instead of installing a viewport for the laser injection; Saito-san agreed (10/12)
One of the feedthrough flanges on the OMC chamber is not tightly connected as there will be one more cable connected to it for a picomotor (10/16)
The feedthroughs cannot be directly connected to the KAGRA Dsub cable; there should be a gender changer inbetween (10/17)

KAGRA/Subgroups/IOO/OMC/installation (last edited 2019-11-15 10:24:08 by KentaroSomiya)

-  ⇤ ← Revision 15 as of 2018-10-17 20:46:55 → 
  Size: 1088
  Editor: KentaroSomiya
  Comment:
+   ← Revision 16 as of 2018-10-17 20:50:46 → ⇥
  Size: 1251
  Editor: KentaroSomiya
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 27:
- * We found that we need two more male pin (accuglass, 100171) to connect the PZT cables to the Dsub cable (10/12)
+ * One of the feedthrough flanges on the OMC chamber is not tightly connected as there will be one more cable connected to it for a picomotor (10/16)

 * The feedthroughs cannot be directly connected to the KAGRA Dsub cable; there should be a gender changer inbetween (10/17)