Differences between revisions 16 and 18 (spanning 2 versions)

Installation work 2018/10-11

Miyoki-san suggested to use an uninterruptible power supply for the omc laser (10/12)
Akutsu-kun suggested to simply remove a blank flange instead of installing a viewport for the laser injection; Saito-san agreed (10/12)
One of the feedthrough flanges on the OMC chamber is not tightly connected as there will be one more cable connected to it for a picomotor (10/16)
The feedthroughs cannot be directly connected to the KAGRA Dsub cable; there should be a gender changer inbetween (10/17)
We moved the Optical Table B (POS table) out from the OMC area; it will be moved to the BS area on Nov 8-9 (10/31)
PD/QPD in-air cables should be relocated so as to have the female connectors to the feedthrough (11/1)

KAGRA/Subgroups/IOO/OMC/installation (last edited 2019-11-15 10:24:08 by KentaroSomiya)

-  ⇤ ← Revision 16 as of 2018-10-17 20:50:46 → 
  Size: 1251
  Editor: KentaroSomiya
  Comment:
+   ← Revision 18 as of 2018-11-01 10:06:45 → ⇥
  Size: 1472
  Editor: KentaroSomiya
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 19:
+[[attachment:180525_output optics saito.xlsx|Coordinates by Saito-san]]
-Line 20:
+Line 22:
- * It turned out that the Table B is to be moved to the SR2 area for ALS (10/11)
 Line 30:
+ * We moved the Optical Table B (POS table) out from the OMC area; it will be moved to the BS area on Nov 8-9 (10/31)

 * PD/QPD in-air cables should be relocated so as to have the female connectors to the feedthrough (11/1)