Differences between revisions 8 and 12 (spanning 4 versions)

Installation work 2018/10-11

It turned out that the Table B is to be moved to the SR2 area for ALS (10/11)
Miyoki-san suggested to use an uninterruptible power supply for the omc laser (10/12)
Akutsu-kun suggested to simply remove a blank flange instead of installing a viewport for the laser injection; Saito-san agreed (10/12)
We found that we need two more male pin (accuglass, 100171) to connect the PZT cables to the Dsub cable (10/12)

KAGRA/Subgroups/IOO/OMC/installation (last edited 2019-11-15 10:24:08 by KentaroSomiya)

-  ⇤ ← Revision 8 as of 2018-10-12 22:52:48 → 
  Size: 856
  Editor: KentaroSomiya
  Comment:
+   ← Revision 12 as of 2018-10-17 10:37:20 → ⇥
  Size: 970
  Editor: KentaroSomiya
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 13:
+[[https://gwdoc.icrr.u-tokyo.ac.jp/DocDB/0091/T1809176/004/FromChart4.pdf|Screws purchased for OMC/OFI]]
-Line 15:
+Line 17:
- - It turned out that the Table B is to be moved to the SR2 area for ALS (10/11)
 - Miyoki-san suggested to use an uninterruptible power supply for the omc laser (10/12)
 - Akutsu-kun suggested to simply remove a blank flange instead of installing a viewport for the laser injection; Saito-san agreed (10/12)
 - We found that we need two more male pin (accuglass, 100171) to connect the PZT cables to the Dsub cable (10/12)
+ * It turned out that the Table B is to be moved to the SR2 area for ALS (10/11)

 * Miyoki-san suggested to use an uninterruptible power supply for the omc laser (10/12)

 * Akutsu-kun suggested to simply remove a blank flange instead of installing a viewport for the laser injection; Saito-san agreed (10/12)

 * We found that we need two more male pin (accuglass, 100171) to connect the PZT cables to the Dsub cable (10/12)