Differences between revisions 26 and 28 (spanning 2 versions)

Output Mode-cleaner

Meetings

To be uploaded.

Shot noise increase due to the signal reduction by the OMC and residual spatial higher order modes after the OMC should be less than 5%.

TBD

TBD

-  ⇤ ← Revision 26 as of 2018-03-12 14:52:20 → 
  Size: 1939
  Editor: KentaroSomiya
  Comment:
+   ← Revision 28 as of 2018-03-12 14:53:37 → ⇥
  Size: 1098
  Editor: KentaroSomiya
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 15:
-=== Requirement ===
+== Requirement ==
 Line 19:
-=== Optical Design (updated 17/11/14) ===
+== Optical Design (updated 17/11/14) ==
 Line 41:
-=== Suspension Design ===
+== Suspension Design ==
 Line 45:
-=== Control Scheme ===
+== Control Scheme ==
 Line 48:
-=== Task List for OMC and OFI (updated 18/3/11) ===
||item||state||
||Design a post||Not yet||
||Make a breadboard for OFI||Not yet||
||Check the extinction ratio of OFI||Not yet||
||Design and make the Transport fixture for OMC||On going||
||Make a mount for PD(for OMC)||Not yet||
||Make a QPD for monitoring alignment of OMC||Not yet||
||Make a control system for alignment of OMC||Not yet||
||Design a frame of suspension for OMC||On going||
||Control test and cabling (in Air and vacuum)||Not yet||
||Make a suspension for OFI||Not yet||
||Install OMC and its suspension||Not yet||
||Install OFI and its suspension||Not yet||
||Simulation of control MIF using beacon signal||Not yet||
||Check the all calculation by Somiya-san about OMC||Not yet||
||Make a control system for OMC in Digital system||Not yet||