Differences between revisions 1 and 3 (spanning 2 versions)

20210203

klog

Workers: Akutsu, N. Sato, K. Tanaka, Nakano

All
- Found that flanges of MCF and MCE chambers were not protected by white tapes although there were viton o-rings on. We protected these by white tapes.
MCi
- Relocated the connector plate.
- Attached adapter structure for black shields onto the pillars of the MCi suspension.
MCo
- Found the connector plate on the MCo suspension was hard to relocate on the optical table in the chamber due to short wires from actuator coils.
MCe

2 metal rack shelves in the clean booth (MCF and MCE); the height must be lower than 180 cm due to lower ceiling of the relevant clean booths.
1 sticky mat to get the dirt off our feet.

KAGRA/Subgroups/SysInt/IMC_O4/2021-02-03 (last edited 2021-02-03 20:40:13 by TomotadaAkutsu)

-  ⇤ ← Revision 1 as of 2021-02-03 18:53:50 → 
  Size: 273
  Editor: TomotadaAkutsu
  Comment:
+   ← Revision 3 as of 2021-02-03 19:06:31 → ⇥
  Size: 810
  Editor: TomotadaAkutsu
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 9:
- * Found that the flanges
+ * All
  * Found that flanges of MCF and MCE chambers were not protected by white tapes although there were viton o-rings on. We protected these by white tapes.
 * MCi
  * Relocated the connector plate.
  * Attached adapter structure for black shields onto the pillars of the MCi suspension.
 * MCo
  * Found the connector plate on the MCo suspension was hard to relocate on the optical table in the chamber due to short wires from actuator coils.
 * MCe
-Line 14:
+Line 21:
- * Metal racks in the clean booth (MCF and MCE); the height must be lower than 180 cm.
 *
+ * 2 metal rack shelves in the clean booth (MCF and MCE); the height must be lower than 180 cm due to lower ceiling of the relevant clean booths.
 * 1 sticky mat to get the dirt off our feet.