= 20210203 =

== klog ==
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=15914]]
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=15916]]
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=15917]]

== Today's activities ==
Workers: Akutsu, N. Sato, K. Tanaka, Nakano
 * All
  * Found that flanges of MCF and MCE chambers were not protected by white tapes although there were viton o-rings on. We protected these by white tapes. -> Informed this to SEO already.
 * MCi
  * Relocated the connector plate.
  * Attached adapter structures for black shields onto the pillars of the MCi suspension. (But not yet the black plates.)
 * MCo
  * Found the connector plate on the MCo suspension was '''hard''' to relocate on the optical table in the chamber due to short wires from actuator coils.
 * MCe
  * Relocated the connector plate.
  * Found the birmndy connector was loose!! Maybe VIS needs to check the other suspensions...
  * Before working, I (Akutsu) stopped the laser source for the tilt sensor; I did not know what was the proper process to stop the laser source, and I could not find any type number of this Thorlabs driver, so we could not search for the manual, so I just turned it off. ''Ashikarazu.''

== Next plan ==
 * Wash some screws.
 * Have VIS to modify the MCo connector.
 * Have VIs to check whether the birndy connectors on the suspension structures are loose or not; at leaast, that for MCe is loose.
 * Have VIS to consider how to tame/fix the electric wires from the coil actuators so that they won't cross the laser beams.
 * Check the ghost beams.

== Wanted! ==
 * 2 metal rack shelves in the clean booth (each for MCF and MCE); the height must be lower than 180 cm due to lower ceiling of the relevant clean booths.
 * 1 sticky mat to get the dirt off our feet.