Size: 1464
Comment:
|
← Revision 49 as of 2020-12-04 11:38:31 ⇥
Size: 1716
Comment:
|
Deletions are marked like this. | Additions are marked like this. |
Line 5: | Line 5: |
{{https://gwdoc.icrr.u-tokyo.ac.jp/DocDB/0120/E2012025/002/VISworkflow-Overview.png|WorkFlow|width=600}} | [[https://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=12025| Flow chart for the acceptance check ]] |
Line 10: | Line 12: |
=== A01 === * hoge |
=== A01 : Simulation satisfy the requirement? === * {i} Please write |
Line 16: | Line 19: |
=== B01 === | === B01 : Tower is ready to combine? === |
Line 32: | Line 35: |
=== B02 === * Please write * ---- |
=== B02 : Payload is ready to combine? === * {i} Please write |
Line 36: | Line 38: |
=== B03 === * Please write * ---- |
=== B03 : Can we measure the TF in air? === * {i} Please write |
Line 40: | Line 41: |
=== B04 === * Please write * ---- == C: Integration phase == [[https://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=xxx|Check sheets templates for C]] === C01 === |
=== B04 : Can we measure the TF in vacuum? === |
Line 53: | Line 47: |
== C: Integration phase == [[https://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=xxx|Check sheets templates for C]] === C01 : Can we control the suspension in local? === |
|
Line 58: | Line 57: |
=== C02 === | === C02 : Can we control the suspension in global? === |
Line 60: | Line 59: |
* ---- | * aaaa |
Acceptance Test
Flow chart
Flow chart for the acceptance check
A: Design phase
A01 : Simulation satisfy the requirement?
Please write
B: Installation phase
B01 : Tower is ready to combine?
- Cable connection
- Resistance (Ohom)
- Continuity (OK/NO)
- Calibration (LVDT, ACC)
- Calibration (plot, polarity, coefficient)
- Sensor noise (plot)
- Working point and dynamic range with FR, Limit SW
- Range (from -mm to +mm)
- Minimum range (mm)
- Optimal point (mm)
- Limit SW (on/off)
- Tuned frequencies of GAS Filter/IP
- Frequency (TF, actuator efficiency)
- Maximum frequency (Hz)
B02 : Payload is ready to combine?
Please write
B03 : Can we measure the TF in air?
Please write
B04 : Can we measure the TF in vacuum?
- Damping time
- RMS in spectrum (plot)
- Healthy check
- Transfer function (plot)
- Resonant frequencies (PreQUA)
C: Integration phase
C01 : Can we control the suspension in local?
- Noise budget
- Spectrum (plot)
- Automation
- check the guardian transition
C02 : Can we control the suspension in global?
- Please write
- aaaa