|
Size: 1996
Comment:
|
Size: 2039
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 12: | Line 12: |
| KAGRA requirements | * KAGRA requirements |
| Line 15: | Line 15: |
Suspension model |
* Suspension model |
| Line 25: | Line 24: |
| Transfer function * transfer function of the suspension Noises * requirement for sensor noises * requirement for actuator noises |
* Transfer function * transfer function of the suspension (ref. xxx) * Noises * requirement for sensor noises (ref. xxx) * requirement for actuator noises (ref. xxx) |
Contents
Acceptance Test
Flow chart
A: Design phase
A01 : Could the simulation satisfy the requirement?
Input
- KAGRA requirements
- Input the design sensitivity (ref. xxx)
- Input the DAC limit (ref. xxx)
* Suspension model
- plant model : rigid body model by SUMCON (ref. xxx)
- control model : LTI model by Matlab simlink (ref. xxx)
- noise model : seismic noise, control noise (ref. xxx)
Content
Output
- Transfer function
- transfer function of the suspension (ref. xxx)
- Noises
- requirement for sensor noises (ref. xxx)
- requirement for actuator noises (ref. xxx)
B: Installation phase
B01
- Cable connection
- Resistance (Ohom)
- Continuity (OK/NO)
- Calibration (LVDT, ACC)
- Calibration (plot, polarity, coefficient)
- Sensor noise (plot)
- Working point and dynamic range with FR, Limit SW
- Range (from -mm to +mm)
- Minimum range (mm)
- Optimal point (mm)
- Limit SW (on/off)
- Tuned frequencies of GAS Filter/IP
- Frequency (TF, actuator efficiency)
- Maximum frequency (Hz)
B02
- Please write
- aaaa
B03
- Please write
- aaaa
B04
- Please write
- aaaa
C: Integration phase
C01
- Damping time
- RMS in spectrum (plot)
- Healthy check
- Transfer function (plot)
- Resonant frequencies (PreQUA)
- Noise budget
- Spectrum (plot)
- Automation
- check the guardian transition
C02
- Please write
- aaaa