Differences between revisions 10 and 12 (spanning 2 versions)
Revision 10 as of 2018-09-25 12:22:58
Size: 778
Editor: MarkBarton
Comment:
Revision 12 as of 2018-11-07 10:28:36
Size: 848
Editor: MarkBarton
Comment:
Deletions are marked like this. Additions are marked like this.
Line 4: Line 4:
See [[KAGRA/Subgroups/DGS/Projects/PicoMotor]]. A lot of the pico setup was done by Miyo-kun. See his page [[KAGRA/Subgroups/DGS/Projects/PicoMotor]].
Line 10: Line 10:
'''Note that there are two subtypes with slightly different behaviour.''' Old type ones have a serial number starting with “1” and new type ones have a serial number starting with “3”. '''The new type ones have to be unplugged from Ethernet before they can be used with the joystick.''' '''Note that there are two subtypes of controllers with slightly different behaviour.''' Old type ones have a serial number starting with “1” and new type ones have a serial number starting with “3”. '''The new type ones have to be unplugged from Ethernet before they can be used with the joystick.'''

KAGRA VIS Operations Manual - Setup and Use of Picomotor Drivers

Back to Operation Manual main page

A lot of the pico setup was done by Miyo-kun. See his page KAGRA/Subgroups/DGS/Projects/PicoMotor.

The picos used in the suspensions are Newport 8302-UHV Ultra-High Vacuum Picomotor Actuator, 1.0" Travel, 0.375" Shank.

The pico controllers are Newport 8742-4-KIT Picomotor Controller/Driver Kit.

Note that there are two subtypes of controllers with slightly different behaviour. Old type ones have a serial number starting with “1” and new type ones have a serial number starting with “3”. The new type ones have to be unplugged from Ethernet before they can be used with the joystick.

Using the Pico motors for BS. See KAGRA/Subgroups/VIS/OpsManual/Pico/BS_Picos.

KAGRA/Subgroups/VIS/OpsManual/Pico (last edited 2021-07-19 14:06:01 by satoru.ikeda)