313
Comment:
|
893
|
Deletions are marked like this. | Additions are marked like this. |
Line 11: | Line 11: |
== /users/VIS/TypeA/ == ==== Striptool configuration files ==== * /users/VIS/TypeA/${suspension}/monitor_config/stp_files * where suspension=ETMX, ETMY, ITMX or ITMY. ==== dv configuration files ==== * /users/VIS/TypeA/${suspension}/monitor_config/dv_files * where suspension=ETMX, ETMY, ITMX or ITMY. ---- == /users/VIS/TypeA/general/ == === axis_check/ === * 20190928/ * The time series when each IP-stage was steered in DC. * 20191009/ * measurement files in .xml and the scripts to get the angle offset and the figures. |
Measurement information
- The information of dir is (will be) listed in this page.
- This page basically focuses on:
- /users/VIS/TypeA/
- /users/VISsvn/TypeA${part}/
- where part=tower or part=payload
- Also this focuses on the measurements by Y. Fujii from 2018 to 2019.
- This page basically focuses on:
/users/VIS/TypeA/
Striptool configuration files
- /users/VIS/TypeA/${suspension}/monitor_config/stp_files
- where suspension=ETMX, ETMY, ITMX or ITMY.
dv configuration files
- /users/VIS/TypeA/${suspension}/monitor_config/dv_files
- where suspension=ETMX, ETMY, ITMX or ITMY.
/users/VIS/TypeA/general/
axis_check/
- 20190928/
- The time series when each IP-stage was steered in DC.
- 20191009/
- measurement files in .xml and the scripts to get the angle offset and the figures.