893
Comment:
|
1290
|
Deletions are marked like this. | Additions are marked like this. |
Line 32: | Line 32: |
=== bruco/ === * test files to run the bruco |
|
Line 34: | Line 36: |
=== calib/ === * Measurement files for the length-oplev calibration with hte arm cavities. === for_summary/ === * Some of the scripts and the output figures used in PhD thesis by Y. Fujii. === implemented_filter_info/ === * The filter information which was used at the date which the dir_name shows, especially at ETMX. |
Measurement information
- The information of dir is (will be) listed in this page.
- This page basically focuses on:
- /users/VIS/TypeA/
- /users/VISsvn/TypeA${part}/
- where part=tower or part=payload
- Also this focuses on the measurements by Y. Fujii from 2018 to 2019.
- This page basically focuses on:
/users/VIS/TypeA/
Striptool configuration files
- /users/VIS/TypeA/${suspension}/monitor_config/stp_files
- where suspension=ETMX, ETMY, ITMX or ITMY.
dv configuration files
- /users/VIS/TypeA/${suspension}/monitor_config/dv_files
- where suspension=ETMX, ETMY, ITMX or ITMY.
/users/VIS/TypeA/general/
axis_check/
- 20190928/
- The time series when each IP-stage was steered in DC.
- 20191009/
- measurement files in .xml and the scripts to get the angle offset and the figures.
bruco/
- test files to run the bruco
calib/
- Measurement files for the length-oplev calibration with hte arm cavities.
for_summary/
- Some of the scripts and the output figures used in PhD thesis by Y. Fujii.
implemented_filter_info/
- The filter information which was used at the date which the dir_name shows, especially at ETMX.