Measurement information

• The information of dir is (will be) listed in this page.
  • This page basically focuses on:
    • /users/VIS/TypeA/
    • /users/VISsvn/TypeA${part}/
    • where part=tower or part=payload
  • Also this focuses on the measurements by Y. Fujii from 2018 to 2019.

/users/VIS/TypeA/

Striptool configuration files

• /users/VIS/TypeA/${suspension}/monitor_config/stp_files
  • where suspension=ETMX, ETMY, ITMX or ITMY.

dv configuration files

• /users/VIS/TypeA/${suspension}/monitor_config/dv_files
  • where suspension=ETMX, ETMY, ITMX or ITMY.

/users/VIS/TypeA/general/

axis_check/

• 20190928/
  • The time series when each IP-stage was steered in DC.
• 20191009/
  • measurement files in .xml and the scripts to get the angle offset and the figures.

bruco/

• test files to run the bruco

calib/

• Measurement files for the length-oplev calibration with hte arm cavities.

for_summary/

• Some of the scripts and the output figures used in PhD thesis by Y. Fujii.

implemented_filter_info/

• The filter information which was used at the date which the dir_name shows, especially at ETMX.

LogNotes/

• To be added

measurement_for_modeling/${suspension}

• This folder contains the measured transfer function information in terms of .txt and .pdf file.

• the fitted zpk information is summarized in fitting-results.txt

monitor_config

• diaggui files which monitors each stage spectra of each suspension is stored.
  • TM_monitor.xml would be useful.