1716
Comment:
|
1878
|
Deletions are marked like this. | Additions are marked like this. |
Line 53: | Line 53: |
=== measurement_for_modeling/${suspension} === | === measurement_for_modeling/${suspension}/ === |
Line 58: | Line 58: |
=== monitor_config === | === monitor_config/ === |
Line 60: | Line 60: |
* TM_monitor.xml would be useful. | * '''''TM_monitor.xml''''' would be useful. === qfactor_measurement/ === * All the measurement files used for the decay-time measurement, which was done with ETMX suspension is stored. |
Line 66: | Line 70: |
Measurement information
- The information of dir is (will be) listed in this page.
- This page basically focuses on:
- /users/VIS/TypeA/
- /users/VISsvn/TypeA${part}/
- where part=tower or part=payload
- Also this focuses on the measurements by Y. Fujii from 2018 to 2019.
- This page basically focuses on:
/users/VIS/TypeA/
Striptool configuration files
- /users/VIS/TypeA/${suspension}/monitor_config/stp_files
- where suspension=ETMX, ETMY, ITMX or ITMY.
dv configuration files
- /users/VIS/TypeA/${suspension}/monitor_config/dv_files
- where suspension=ETMX, ETMY, ITMX or ITMY.
/users/VIS/TypeA/general/
axis_check/
- 20190928/
- The time series when each IP-stage was steered in DC.
- 20191009/
- measurement files in .xml and the scripts to get the angle offset and the figures.
bruco/
- test files to run the bruco
calib/
- Measurement files for the length-oplev calibration with hte arm cavities.
for_summary/
- Some of the scripts and the output figures used in PhD thesis by Y. Fujii.
implemented_filter_info/
- The filter information which was used at the date which the dir_name shows, especially at ETMX.
LogNotes/
- To be added
measurement_for_modeling/${suspension}/
- This folder contains the measured transfer function information in terms of .txt and .pdf file.
the fitted zpk information is summarized in fitting-results.txt
monitor_config/
- diaggui files which monitors each stage spectra of each suspension is stored.
TM_monitor.xml would be useful.
qfactor_measurement/
- All the measurement files used for the decay-time measurement, which was done with ETMX suspension is stored.