|
Size: 2274
Comment:
|
Size: 2474
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 84: | Line 84: |
| * Super messy. | * Super messy and not much meaningful for you since the suspensions were extracted from the chamber once after this measurement and were re-installed. I.e, these measurement have to be done again and have t be updated. |
| Line 92: | Line 92: |
Measurement information
- The information of dir is (will be) listed in this page.
- This page basically focuses on:
- /users/VIS/TypeA/
- /users/VISsvn/TypeA${part}/
- where part=tower or part=payload
- Also this focuses on the measurements by Y. Fujii from 2018 to 2019.
- This page basically focuses on:
/users/VIS/TypeA/
Striptool configuration files
- /users/VIS/TypeA/${suspension}/monitor_config/stp_files
- where suspension=ETMX, ETMY, ITMX or ITMY.
dv configuration files
- /users/VIS/TypeA/${suspension}/monitor_config/dv_files
- where suspension=ETMX, ETMY, ITMX or ITMY.
/users/VIS/TypeA/general/
axis_check/
- 20190928/
- The time series when each IP-stage was steered in DC.
- 20191009/
- measurement files in .xml and the scripts to get the angle offset and the figures.
bruco/
- test files to run the bruco
calib/
- Measurement files for the length-oplev calibration with hte arm cavities.
for_summary/
- Some of the scripts and the output figures used in PhD thesis by Y. Fujii.
implemented_filter_info/
- The filter information which was used at the date which the dir_name shows, especially at ETMX.
LogNotes/
- To be added
measurement_for_modeling/${suspension}/
- This folder contains the measured transfer function information in terms of .txt and .pdf file.
the fitted zpk information is summarized in fitting-results.txt
monitor_config/
- diaggui files which monitors each stage spectra of each suspension is stored.
TM_monitor.xml would be useful.
qfactor_measurement/
- All the measurement files used for the decay-time measurement, which was done with ETMX suspension is stored.
rms_suppression/
toDARM/
utility/
Xarm_measurement/
- The transfer functions of ETMX and ITMX measured with X-arm cavity in Dec. 2018 and Jan 2019.
This folder has the measurement results in .txt and .pdf. The measurement files in .xml is in other dirs (see the plottf.m, for example.)
- Super messy and not much meaningful for you since the suspensions were extracted from the chamber once after this measurement and were re-installed. I.e, these measurement have to be done again and have t be updated.