== Measurement information ==

 * The information of dir is (will be) listed in this page.
  * This page basically focuses on:
    * /users/VIS/TypeA/
    * /users/VISsvn/TypeA${part}/
    * where part=tower or part=payload
  * Also this focuses on the measurements by Y. Fujii from 2018 to 2019.

----
== /users/VIS/TypeA/ ==


==== Striptool configuration files ====
  * /users/VIS/TypeA/${suspension}/monitor_config/stp_files
    * where suspension=ETMX, ETMY, ITMX or ITMY.
  
==== dv configuration files ====
 * /users/VIS/TypeA/${suspension}/monitor_config/dv_files
    * where suspension=ETMX, ETMY, ITMX or ITMY.

----

== /users/VIS/TypeA/general/ ==
=== axis_check/ ===
  * 20190928/
   * The time series when each IP-stage was steered in DC.

  * 20191009/
    * measurement files in .xml and the scripts to get the angle offset and the figures.

=== bruco/ ===
  * test files to run the bruco


=== calib/ ===
  * Measurement files for the length-oplev calibration with hte arm cavities.


=== for_summary/ ===
  * Some of the scripts and the output figures used in PhD thesis by Y. Fujii.


=== implemented_filter_info/ ===
  * The filter information which was used at the date which the dir_name shows, especially at ETMX.


=== LogNotes/ ===
  * To be added



=== measurement_for_modeling/${suspension}/ ===
  * This folder contains the measured transfer function information in terms of .txt and .pdf file.
  * the fitted zpk information is summarized in '''''fitting-results.txt'''''


=== monitor_config/ ===
  * diaggui files which monitors each stage spectra of each suspension is stored.
    * '''''TM_monitor.xml''''' would be useful.


=== qfactor_measurement/ ===
 * All the measurement files used for the decay-time measurement, which was done with ETMX suspension is stored.


=== rms_suppression/ ===
 * 



=== toDARM/ ===
 * 


=== utility/ ===
 * 



=== Xarm_measurement/ ===
 * The transfer functions of ETMX and ITMX measured with X-arm cavity in Dec. 2018 and Jan 2019.
 * This folder has the measurement results in .txt and .pdf. The measurement files in .xml is in other dirs (see the '''''plottf.m''''', for example.)
 * Super messy and not much meaningful for you since the suspensions were extracted from the chamber once after this measurement and were re-installed. I.e, these measurement have to be done again and have t be updated.

----

== /users/VISsvn/TypeA${part}/ ==