|
Size: 3203
Comment:
|
Size: 2036
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 2: | Line 2: |
| Line 6: | Line 5: |
| ==== Report for week of 10/1 ==== ===== SR2 ===== * We solved a mystery with the height of the BF keystone: it turns out that running the table KOACH filters in the tank warms it up (by about 1.5°C) and causes significant sag (700 µm). D'oh! * We ran power to the pico drivers. * We got the lower section of the SR2 fairly well aligned with just a bit of adjustment with the IM pitch and roll picos. * We helped Lucia double-check the geometry of the IP - the current matrix calculation assumes the FRs and the LVDT sensors and actuators are colocated, which is much closer to true than for the BS, but not quite right. * We gave up on doing anything more with SR2 for now because we're waiting on extra extension cables for the PI and Fujii-kun will want to borrow one of the geophones next week for a huddle test with new geophones. ===== SRM ===== * We set the pitch of the SRM and RM, tightened the clamps and removed the winch system. * We installed the BF crossbars of the assembly frame and the BF ring section of the security structure. * We lifted the IM/... section on the load gauge to find its weight. * We craned in the BF and removed the cap. * We installed the BF-IRM rods and the IRM top plate. * We installed the BF-IM maraging rod and flying saucer cable clamps. * We suspended the IM/... section and adjusted the trim masses for balance and total mass. It took quite a lot of adjustment in each of pitch, roll and vertical. The vertical was due to the fact that the weight of the IM/... section is very close to that of SR2/SR3 but the SRM BF is about 0.5 kg weaker. The roll was due to the fact that the default configuration of trim mass had no correction for the horizontal wedge on the optic. However the pitch is a bit of a mystery - nearly all of the removed mass had to come off the AR side. Fortunately we were able to correct for it entirely with masses we had in hand. * We routed the TM OSEM cables via the flying saucer up to the underside of the BF. * We got 2 power supplies from Shimode-san so we can fire up the SRM rack next week. He will also supply suitable cables to connect the power supplies to the DC power strip in the rack. * We received the replated yoke for the SRM top filter. |
==== Report for the week of 4/1 ==== * Support of Type Bp * Hirata-san procured the jigs for PRs and Takahashi-san tested one at TAMA. * Hirata-san cleaned up the flags for PR2 and Mark did the one for PRM. * Fabian helped Fujii-kun and Takashashi-san to reglue the flags. * Mark did a lot of maintenance on the MEDM screens: * Made the name of the suspension more obvious (no yellow text!). * Added rack temperature indicators. * Fixed the labels in the ADC screen (to reflect the LEN OL moving from ADC#0 to #1). * Fixed broken links. * Committed files to the SVN. * Mark did maintenance on the Guardian to make it give more helpful messages in the TRIGGER state. Formerly it only checked the user model watchdog and the coil driver watchdog, not the DACKILL, and gave the same generic notification for both. Now it checks all three and tells the user which need attention. * Mark tidied up the cables in the SR2 rack and returned a large pile of no-longer-used cables to the tent. * Mark started a !HealthCheck page on the Operation Manual wiki. Fabian and Mark ==== Plan for week of 4/8 ==== * Mark, Fabian at Kamioka Mon-Fri. * Help with Type Bp. * Health checks on Type B. * Monitor pumpdown. * Work on Type B paper. * Modify RT models and/or Guardian to revert to the SAFE state under control in all but the most extreme emergency situations (rather than suddenly shutting off all output). * Tidy up. * Gather and clean tools. * Gather and organize unused parts and fasteners. |
| Line 25: | Line 31: |
| ==== Plan for week of 10/8 ==== * Monday 10/8 is Sports Day. * Enzo returns Tuesday 10/9. * Mark and Terrence (plus TBD) at Kamioka Mon-Fri. * Enzo, Hirata-san, Fabian and Panwei at Kamioka Tue-Fri. ===== SR2/SR3 ===== * Terrence to set up LEN half of SR3 OL and, time permitting, TILT and LEN for SR2. ===== SRM ===== * Cable/test BF. * Install IRM. * Install/cable/test IM OSEMs. * Suspend/weigh/balance the BF/... section. |
==== Plan for week of 4/15 ==== * Mark at Mitaka 4/15, Kamioka 4/16-18, f2f 4/19. * Fabian at Kamioka 4/15-18, f2f 4/19. |
| Line 38: | Line 35: |
| ==== To-Do Lists, Schedule ==== * [[KAGRA/Subgroups/VIS/TypeB/ToDoBS]] * [[KAGRA/Subgroups/VIS/TypeB/ToDoSR]] * [[https://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=7779|JGW-L1807779 Type B Schedule (SR)]] ==== Vacation/Visitor Info ==== * Enzo: 9/15 through 10/8 vacation in Chile. * Terrence: 10/8-12, 10/29-11/2 at Kamioka. |
==== Vacation/Travel Info ==== * Mark at Mitaka 4/15. * f2f 4/19 (Friday), 4/20, 4/21. * Terrence's next visit from 4/18. * Fabian's vacation 4/26 to 5/10. * Mark's vacation from about 5/22 to 6/11. * Mark's final day 6/28. |
Scraps of text for incorporation in the VIS Meeting Minutes
KAGRA/Subgroups/VIS/MeetingNAOJ
Type B (Mark)
Report for the week of 4/1
- Support of Type Bp
- Hirata-san procured the jigs for PRs and Takahashi-san tested one at TAMA.
- Hirata-san cleaned up the flags for PR2 and Mark did the one for PRM.
- Fabian helped Fujii-kun and Takashashi-san to reglue the flags.
- Mark did a lot of maintenance on the MEDM screens:
- Made the name of the suspension more obvious (no yellow text!).
- Added rack temperature indicators.
- Fixed the labels in the ADC screen (to reflect the LEN OL moving from ADC#0 to #1).
- Fixed broken links.
- Committed files to the SVN.
- Mark did maintenance on the Guardian to make it give more helpful messages in the TRIGGER state. Formerly it only checked the user model watchdog and the coil driver watchdog, not the DACKILL, and gave the same generic notification for both. Now it checks all three and tells the user which need attention.
- Mark tidied up the cables in the SR2 rack and returned a large pile of no-longer-used cables to the tent.
Mark started a HealthCheck page on the Operation Manual wiki.
Fabian and Mark
Plan for week of 4/8
- Mark, Fabian at Kamioka Mon-Fri.
- Help with Type Bp.
- Health checks on Type B.
- Monitor pumpdown.
- Work on Type B paper.
- Modify RT models and/or Guardian to revert to the SAFE state under control in all but the most extreme emergency situations (rather than suddenly shutting off all output).
- Tidy up.
- Gather and clean tools.
- Gather and organize unused parts and fasteners.
Plan for week of 4/15
- Mark at Mitaka 4/15, Kamioka 4/16-18, f2f 4/19.
- Fabian at Kamioka 4/15-18, f2f 4/19.
Vacation/Travel Info
- Mark at Mitaka 4/15.
- f2f 4/19 (Friday), 4/20, 4/21.
- Terrence's next visit from 4/18.
- Fabian's vacation 4/26 to 5/10.
- Mark's vacation from about 5/22 to 6/11.
- Mark's final day 6/28.