VIS Type B Near Term To-Do List

../ToDoOld

Every Week

Facilities (mostly full team)

• Clean up after floor work.
• Vacuum and roll floor.
• Wipe ladders.
• Tidy tools, parts.

2017-04-03

SF/BF/...

• Trim BF to correct pitch/roll.
• Install temporary ballast mass in SF.
• Lift SF/BF/... and check SF pitch/roll balance and overall weight.

Continue PI Prep

• Finish reattaching repaired LVDT coil(s) and redoing connectors with correct gender.
• Install fishing rod.
• Enlarge ring of crane adapter.
• Find table, weights, etc for use with LBB blade bending jigs.
• Set up LBB blade tensioning jig.
• Install LLB blades.
• Install LLB blade units in PI.

Hanging BF/IRM/IM/RM/BS (mostly Mark, Fabian, Perry)

• Test SF LVDT.
• Test SF fishing rod stepper.
• Debug TM-H4.

Electronics (mostly Enzo, Mark)

• Add retaining screws to cables at feedthroughs (mostly done, needs finishing).
• Work with Miyo-kun to get pico drivers added to BS rack and screens
• Update E1503600 with DIO card for HPCDs, etc, etc.
• Decide final length for BS OSEM cables (Enzo, Mark, Fabian)
• Send list of required in-vacuum cables to Takahashi-san
• Make table of ADC/DAC assignments and check for consistency with D1503600 and k1visbs (Enzo, Mark)
• Make spreadsheet on Google Docs or the like with in-vacuum cable inventory (Hirata)

Real-time and SUMCON models (mostly Perry, Mark)

• Create a proper DAC Monitor MEDM screen.
• Improve ADC Monitor MEDM screen.