VIS Type B Near Term To-Do List

2017-03-13

Facilities

• Vacuum and roll floor (All)
• Wipe ladders (All)
• Tidy tools, parts (All)
• Find missing light lent to Kokeyama-san (Mark)
• Mark/photograph/count peeling patches on the floor.
• Mark/photograph/count pillars with bare concrete bases.

Electronics

• Wire up BF roll/pitch picos (Enzo)
• Work with Miyo-kun to get pico drivers added to BS rack and screens (Enzo, Mark)
• Grab remaining cables etc per E1605111 and update document (Enzo)
• Update E1503600 with DIO card for HPCDs, etc, etc. (Enzo)
• Decide final length for BS OSEM cables (Enzo, Mark, Fabian)
• Send list of required in-vacuum cables to Takahashi-san (Enzo, Mark)
• Debug 900 Hz noise on BF LVDT output (Enzo, Mark)
• Debug excess noise on TM-H3 OSEM (Enzo, Mark)
• Make table of ADC/DAC assignments and check for consistency with D1503600 and k1visbs (Enzo, Mark)
• Make spreadsheet on Google Docs or the like with in-vacuum cable inventory (Hirata)

PI Prep

• Inspect PI, compare to CAD and 2D drawings (Hirata, Mark)
• Identify missing PI parts (Hirata, Mark)
• Find and reattach repaired LVDT coil(s) (???)

Hanging BF/IRM/IM/RM/BS

• Correct orientation of SF cap (Mark, Fabian, Perry)
• Correct orientation of SF (Mark, Fabian, Perry)
• Find/attach cable clamps for SF (Fabian)

Real-time and SUMCON models

• Update SUMCON model of full BS (Perry?, Okutomi?, Mark?)
• Do cut-down SUMCON model of just payload hanging from fixed BS (Perry?, Okitomi?, Mark?)
• Compare measured TFs to cut-down model
• Create a proper DAC Monitor MEDM screen
• Improve ADC Monitor MEDM screen