Differences between revisions 43 and 210 (spanning 167 versions)

VIS Type B BS Near Term To-Do List

This list has been merged into the common Type B list: ../ToDo.

Archived BS To-Do Items

KAGRA/Subgroups/VIS/TypeB/ToDoBS (last edited 2019-01-04 15:21:23 by MarkBarton)

-  ⇤ ← Revision 43 as of 2017-05-26 13:47:44 → 
  Size: 1754
  Editor: MarkBarton
  Comment:
+   ← Revision 210 as of 2019-01-04 15:21:23 → ⇥
  Size: 155
  Editor: MarkBarton
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 1:
-= VIS Type B Near Term To-Do List =
+= VIS Type B BS Near Term To-Do List =
 Line 3:
-[[../ToDoOld|Archived To-Do Items]]
+This list has been merged into the common Type B list: [[../ToDo]].
 Line 5:
-[[../BSTestHangIssues|Issues to fix after BS Test Hang]]

== Every Week ==
=== Facilities ===
 * Vacuum and roll floor.
 * Wipe ladders.
 * Tidy tools, parts.

== 2017-05-29 ==

=== Facilities ===

=== Design/Purchasing ===
 * Order longer threaded rods for arc weights on PI.
 * Get more cable ties.
 * Get another D-Sub breakout.

=== Main Assembly ===
 * Reinstall blades in LBB blade units.
 * Do load test on LBB blade units.
 * Try rearranging arc weights to make room for magic wand.
 * 

=== Electronics ===
 * Route BF/... cabling up past SF to PI.
 * Route SF cabling up to PI.
 * Add Type 3 extensions to SF/... cables.
 * Move vacuum flanges to positions on assembly frame more convenient for next stage (accessible from second floor, one on each corner of frame).
 * Move in-air cabling to match flange positions.
 * Cable and test PI vertical LVDT.
 * Calibrate PI vertical LVDT.
 * Set yoke on PI vertical LVDT (if necessary).
 * Cable and test PI yaw stepper.
 * Cable and test PI vertical stepper.
 * Cable and test PI horizontal steppers.
 * Cable and test PI horizontal LVDTs.
 * Calibrate PI horizontal LVDTs.

== Real-time and SUMCON models ==
 * Check PI section of k1visbs model.
 * Make table of ADC/DAC assignments and check for consistency with D1503600 and k1visbs (Enzo, Mark)
 * Understand/document/debug Kokeyama-san's DIO stuff.
 * Measure LPCD and HPCD output filter response.
 * Design and install software compensation filters for LPCD and HPCD output filters.
 * Design and install GAS drift compensation filters.
 * Create a proper DAC Monitor MEDM screen.
 * Improve ADC Monitor MEDM screen.
+[[../ToDoOldBS|Archived BS To-Do Items]]