VIS Type B Wish List

Parts/Screws

• Cu O-rings for geophones
  • As of 2018-04-15
    • We have 3 x 150-mm and 4 x 80-mm ones.
    • We need 4 x 150-mm and 4 x 80-mm for SR
    • We need 3 x 150-mm and 3 x 80-mm if we service the BS geophones.
    • We need 1 x 150-mm and 1 x 80-mm spare.

  • -> ORDER 5 x 150-mm and 4 x 80-mm

• Rubber pieces for geophones.
  • (3mm * ≈Ø77)*9

Tools we'd like soon

• Right-angled forceps like these

• 41-mm wrenches (three if possible) for jacks on tanks, e.g., TOP RS-41.

Tools etc that it would be nice to have

• Extra crimping tool
• Extra pin-removal tool
• Needle-nosed pliers
• Standard hex wrench set
• Short hex wrench set
• Vibrating engraving tool
• More vacuum-compatible tags
• More vacuum-compatible heat shrink
• Bare or Kapton-coated Cu wire for use as cable ties

Things already ordered

• Multimeter (with ohmmeter and diode check function), e.g., Fluke 114

• Nutdriver

• DSub9 Breakouts, e.g., male and female. One set for use at the rack (dirty) and one set for use in the cleanbbooth (clean). (The one we have is this one but it's ridiculously expensive and not even very convenient.)