= iKAGRA VIS electronics review =
2016/2/4 15:00 -

Participants: Takahashi, Aso, Mark, Shoda, Raffaele, Akutsu, Okutomi, Fujii, Sekiguchi

== Minutes ==
 * PR3 electronics diagram (Mark)
  * https://db.tt/vg6TQYYa
  * https://db.tt/xKopUuUz
 * Discussion
  * We went through the cables for PR3.
   * Overview diagram was drawn on a white board ([[attachment:IMG_2565.jpeg|picture]])
    * Blue double circles indicates cables to be replaced from the test hanging (because of wrong pin-out).
    * Red check marks mean we checked the corresponding cable
   * Missing parts -> nothing
   * Connection between an LVDT driver and an ADC required a gender changer. Against the general policy of KAGRA electronics, the output connector of the LVDT driver is male (output should be female in the policy). Therefore, a gender changer was necessary. We should add a gender changer at the output of the LVDT driver.
   * Picomotor cabling was done differently from Mark's diagram
    * We will keep the wiring as is for iKAGRA
    * Make a new DCC document for iKAGRA PR3 cable diagram.
    * Make a modification in this new document. Put a note that the wiring is different in bKAGRA.
   * Stepper motor: TMCM box design will be circulated to VIS and AEL by Shoda by the end of Feb.
  * Future improvement
   * We need an overview schematic like the one drawn in the meeting with links to more detailed documents.
   * From the schematic, we should generate a table of necessary cables
   * We should use this table to check if we have all the necessary cables