Size: 5243
Comment:
|
Size: 5309
Comment:
|
Deletions are marked like this. | Additions are marked like this. |
Line 5: | Line 5: |
13:30- | 13:30-14:00 |
Line 7: | Line 7: |
Participants: | Participants: Takahashi, Sato, Hirata, Ikeda, Miyo, Hagiwara, Kimura, Aso, Tomaru, Ushiba, Akutsu |
Line 17: | Line 17: |
14:00- | 14:00-15:30 |
Line 19: | Line 19: |
Participants: | Participants: Takahashi, Fabian, Hirata, Iguchi, Ishizaki, Miyo, Tanaka, Sato, Suguyama, Terrence, Aso |
Line 36: | Line 36: |
---- /!\ '''Edit conflict - other version:''' ---- |
|
Line 44: | Line 40: |
---- /!\ '''Edit conflict - your version:''' |
=== Type-A === * We went to clean-up of each clean booth. |
Line 47: | Line 43: |
---- ---- /!\ '''End of edit conflict''' ---- === Type-A === |
|
Line 64: | Line 53: |
---- /!\ '''Edit conflict - other version:''' ---- ---- /!\ '''Edit conflict - your version:''' ---- |
|
Line 78: | Line 58: |
---- /!\ '''End of edit conflict''' ---- |
|
Line 85: | Line 61: |
* More three channels are not available in 1U chassis. 2U chassis are necessary with bridge cable. |
|
Line 92: | Line 70: |
* Guardian update is planed on 21 in PR and BS. |
Agenda/Minutes on 2020/10/16
CRY+VIS Interface Meeting
13:30-14:00
Participants: Takahashi, Sato, Hirata, Ikeda, Miyo, Hagiwara, Kimura, Aso, Tomaru, Ushiba, Akutsu
Cable bandling bellow BF.(Assy small hexagon for BF-CRYO.pdf)
- PF actuator
IP monitoring improvement in vacuum pumping -> auto-tracking system
- safe mode switching schedule of WAB
- Yano-san's schedule
VIS Meeting
14:00-15:30
Participants: Takahashi, Fabian, Hirata, Iguchi, Ishizaki, Miyo, Tanaka, Sato, Suguyama, Terrence, Aso
Progress report
General
[Fabian]
I wrote a document about the procedure to replace the LVDT cards after a failure: JGW-T2012128.
- It was checked by Alessandro Betolini from Nikhef and he says the method is correct. He provided minor comments that have been incorported to the new version of the document.
- He says they will review the design for ETpathfinder and that's our chance to give them feedback (i.e. Tanaka-san's findings and my concerns as a user).
- Knowledge transfer from Tanaka-san to Alessandro would be greatly beneficial for KAGRA. If you think it's suitable, would it be possible for someone to organize this, please?
- Tanaka-san will take some of our LVDT cards for hardware modification.
We need to survey those LVDT cards before he takes them away. When will we do this?
As far as I understand, given the old calibration factor, he has to give us a procedure to calculate a new calibration factor. Is this statement correct?
Before any other card breaks, we need to survey all of them. When will we do this?
Four hands are required for the measurements. For Type-B/Bp, Washimi-san and Fabian can do it.
After cleaning the PR area I have the impression we lost Hirose-san's LED lamps to check mirror cleanliness.
[Washimi]
Type-A
- We went to clean-up of each clean booth.
Type-B
- I gave some feedback for the noise budget paper.
- We finished the cleaning with a lot of help.
- Hirata-san made M6 holes in some ballast masses.
- We removed some cables from chassis for the cleaning procedure.
- I put the fibre optic camera in the PR clean booth buffer area.
- We recovered the suspensions after blackout. They all went to ALIGNED state well.
- The temperature has decreased a lot inside the clean rooms, likely due to an increase of cold air circulation after turning all FFUs on. A couple of DC control loops in GAS filters are about to saturate. I've reported this to Miyoki-san and he turned on some heaters.
Type-Bp
- After the blackout PR2 went to ALIGNED state well. PR3 and PRM oplevs were removed before recovery and I just checked they went to TWR_DAMPED state. I can turn the IM control system on by hand to check the health of IM-OSEMS.
- Just for the record for new comers: I realized PR use different amplitudes of reference signals for the LVDTs. According to labels attached to signals generators:
- PR2: 6 Vpp.
- PR3 and PRM: 7 Vpp.
Type-C
Controls
Electronics
- More three channels are not available in 1U chassis. 2U chassis are necessary with bridge cable.
Towards O4
- RSE Trial was finished on Oct. 13th.
- Preparation work is on going.
- Monitoring for vent. Date: 19(only EYV), 22-25(practically 22-23). Charge: Miyo, Ikeda, Fabian, Takahashi
- Guardian update is planed on 21 in PR and BS.
- Schedule.
- Procedure documents.
- Criteria in the acceptance test.
Safety
Discussion
Travel Plans
The week from 10/19
- Takahashi: 10/19-10/23
The week from 10/26
- Hirata: ?
Next meeting
- On 2020/10/23(Fri)