Agenda/Minutes

Zoom Meeting

CRY+VIS Interface Meeting

Date: 2021/12/24 13:00-

Participants:

Post O3 Upgrade portal

Schedule

• IX: Pump down on 12/23. Glich in the F3 signals.
• EX: In vacuum.
• IY:
• EY: Recovery of the BF problem.

Status

• Replacement of flip cables:
• TM height setting: ITMY.
• Oplev: Setup of the TM Oplev in IY after the TM alignment.
• ACC: Experiments in IX/EX. Assembly for EY.
• Commissioning in air: Return of GRY.
• Commissioning in vacuum: Pump down of IXC/IXV on 12/23.
• Overall commissioning:
• Acceptance check:
• PF actuator: At the in-vacuum commissioning.
• New vacuum pumps for V-chambers:
• Heater control:
• Power source for Oplev:

Discussion

VIS Meeting

Date: 2021/12/24 14:00-

Participants:

Summary Report

Type-A

ETMY

• Coil direction check for IP, GAS, and BF.

  • IP H1 H2 and H3 coils are all inverted. https://klog.icrr.u-tokyo.ac.jp/osl/?r=19295

  • F2, F3, BF GAS coils are inverted. https://klog.icrr.u-tokyo.ac.jp/osl/?r=19303

  • BF V1, V3, H2 coils are inverted. https://klog.icrr.u-tokyo.ac.jp/osl/?r=19309

  • Is there any reason why some of them are inverted? The coil output gains are now kind of messy.

• IP LVDT sensing and actuation diagonalization. https://klog.icrr.u-tokyo.ac.jp/osl/?r=19301, https://klog.icrr.u-tokyo.ac.jp/osl/?r=19302

• Some questions
  • BF LVDT readouts are very large, they read a few thousand um/urad. Are they calibrated?
  • Some GAS filters are some thousand microns away from the setpoint. Can I simply use the stepper motors to offload them? Is there anything I should pay attention to?

Type-B

Type-Bp

Type-C

Electronics

Control

Schedule

See Schedule

• Type-A team: ACC in EY, Heter test in IXV/EXV
• Type-B team:

Safety

Discussion

Travel Plans

(Date in Kamioka)

The week from 12/27

(Holidays in 12/29-1/3)

The week from 1/4

• Takahashi: 1/5-7
• Sato: 1/5-7
• Hirata: 1/5-7

Next meeting

• 2022/1/7(FRI)