Differences between revisions 2 and 3
Revision 2 as of 2018-03-13 23:41:31
Size: 422
Comment:
Revision 3 as of 2018-03-13 23:52:47
Size: 1572
Comment:
Deletions are marked like this. Additions are marked like this.
Line 6: Line 6:
 *  * Accepted a BRT and two fixed stages at the entrance of Shin-Atotsu.
 * Brought the BRT and a fixed stage to Yend via Mozumi entrance; left one stage in the center area.
  * '''''Lesson''''': need to put some small suspensions into the delivery box in advance...
  * One stage will be delivered to Xend in April after the cryopayload will be rolled into the EXC chamber.
 * In case, left the stuffs for a day to avoid bedewing.
Line 11: Line 15:
 * Thanks to Mirapro, the chain block got an shade.
Line 13: Line 18:
 * Measure the tilts of the base plate in EYT in several directions
 * Locate the stage on the base plate within XXX tilts.
 * Measure the height with a laser leveler?
 * Locate the BRT on the stage base on XXX as references.
 * Make GPT on the optical table
 * Make a model to drive signals from the TMS
 * Check the response of the TMS by swinging BS, PR2, PR3... etc... with commissioning people
Line 16: Line 28:
 * '''''Ethanol'''''!!
 * Wrenches! Small and big.
 * Laser leveler. レーザー墨出器
 * スリングとか。固定台もちあげるため
 * 水準器各種。
 * Extension cables for power supply 延長ケーブル
 * Markers (black and white)

20180313

Today's activities

Workers: Furuta, Hayakawa, Morita, Awai, Yokogawa, Sugimoto, Akutsu and many helps.

  • Accepted a BRT and two fixed stages at the entrance of Shin-Atotsu.
  • Brought the BRT and a fixed stage to Yend via Mozumi entrance; left one stage in the center area.
    • Lesson: need to put some small suspensions into the delivery box in advance...

    • One stage will be delivered to Xend in April after the cryopayload will be rolled into the EXC chamber.
  • In case, left the stuffs for a day to avoid bedewing.

Dones

  • Thanks to Awai-san, Sawada-san, Miyoki-san, the EYT booth got lights!
  • Thanks to Kimura-san, the top lid of EYT was already opened! And the side flange was almost opened.
  • Thanks to Mirapro, the chain block got an shade.

Next plan

  • Measure the tilts of the base plate in EYT in several directions
  • Locate the stage on the base plate within XXX tilts.
  • Measure the height with a laser leveler?
  • Locate the BRT on the stage base on XXX as references.
  • Make GPT on the optical table
  • Make a model to drive signals from the TMS
  • Check the response of the TMS by swinging BS, PR2, PR3... etc... with commissioning people

Wanted!

  • Ethanol!!

  • Wrenches! Small and big.
  • Laser leveler. レーザー墨出器
  • スリングとか。固定台もちあげるため
  • 水準器各種。
  • Extension cables for power supply 延長ケーブル
  • Markers (black and white)

KAGRA/subgroup/AOS/TMSY1/2018-03-13 (last edited 2018-03-13 23:55:34 by TomotadaAkutsu)