= 20180315 =
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=4478]]

== Today's activities ==
Workers: Akutsu, Yokogawa, Sugimoto
 * Fixed the body of the fixed stage.
  * Aligned the body of the fixed stage (along with the top plate put on it) by slightly hooking up it with three slings, and screwed to the base plate.
  * Aligned the top plate on the fixed stage body by slightly hooking up it with four slings and four M10 eye bolts (Hirata-san gave us), and screw to the body carefully.
  * Measured the tilt on the top plate; '''''should be reported later'''''
 * Installed the BRT.
  * Brought the box of the BRT close to the clean booth; did some tricky treatment to go through a narrow passage between the pillars of clean booth and the ducts on the floor; to literally "overcome" obstacles, put a plate underneath the wooden box.
  * Hooked up the BRT and down into EYT, and roughly alingned, and tightened by screws.
  * Measured the tilt on the top plate; '''''should be reported later'''''
 * Removed covers for each optic of the BRT.
  * There were some parts where I cannot easily reach my fingers to grab the screws to fix the covers to the body of the holders.

== Next plan ==
 * Measure the height with a laser leveler?
 * Locate the BRT on the stage base on XXX as references.
 * Make GPT on the optical table
 * Make a model to drive signals from the TMS
 * Check the response of the TMS by swinging BS, PR2, PR3... etc... with commissioning people
 * Endのend用のフランジとりつけ。たぶん最後のほうで。
 * そこのフランジにとりつける透過光用ビューポート。まだ柏にあるはず。
 * 外側の光学定盤の上の取り回しを考えよ。

== Wanted! ==
 * '''''Four M10 eye bolts'''''
 * M8 SDC bolts? to tighten the top plate to the stage body are '''''shortened'''''!
 * Markers (black and white)

== From VIS ==
 * Four clean slings (from Hirata-san)