Differences between revisions 2 and 3
⇤ ← Revision 2 as of 2019-07-03 12:00:37 →
Size: 1080
Editor: YutaMichimura
Comment:
← Revision 3 as of 2019-07-20 04:58:50 → ⇥
Size: 1152
Editor: YutaMichimura
Comment:
Deletions are marked like this. Additions are marked like this.
Line 19: Line 19:
 * Check how to fill the gaps between panels and optical table surface

Optical Table Cover Review on 2019/07/02 13:00 - 13:30

Participants: Yutaro Enomoto, Shinji Miyoki, Yoichi Aso, Masayuki Nakano, Naohisa Satou, Ryosuke Sugimoto, Yuta Michimura

Zoom meeting: https://zoom.us/j/6676627462

Materials

Minutes

  • Check with Airtech on how to fix the FFU. From the bottom?
  • 2 holes for cables on each side. Make diameter from 60 mm to 100 mm
  • Removal panels with handles also for the sides
  • Holes for fiber poles must be at the edge of the panels.
  • Check how to remove the panels with handles.
  • Check the height of the cover if it interferes with clean booth poles
    • Checked on July 2 and it was OK
  • Check how to fill the gaps between panels and optical table surface

KAGRA/subgroup/ifo/MIF/Minutes20190628 (last edited 2019-07-20 04:58:50 by YutaMichimura)