Differences between revisions 3 and 4
⇤ ← Revision 3 as of 2012-03-04 17:20:13 →
Size: 1140
Editor: TomotadaAkutsu
Comment:
← Revision 4 as of 2012-03-04 17:20:33 → ⇥
Size: 1092
Editor: TomotadaAkutsu
Comment:
Deletions are marked like this. Additions are marked like this.
Line 20: Line 20:
=== Naming Conventions ===
Not applicable.
Line 24: Line 22:
 * Anywhere in the initial alignment phase. Anywhere in the initial alignment phase.

Beam Profiler for large beams

Related subgroups: IOO, MIF, VAC

..Up

Contents

  1. Beam Profiler for large beams
    1. Scope
    2. Applicable Documents
    3. General Description
      1. Functions
      2. Locations
    4. Requirements
    5. Characteristics
    6. Inspection plans
    7. Procurement process and plans
    8. Links

Scope

The scope of Beam Profiler for large beams is to check the beam mode in the phase of initial alignment of optics.

Applicable Documents

General Description

The mode matching is one of the important step to construct an optical cavity. For KAGAR, the beam size will be about 10cm diameter, while there are no such an equipment that is able to measure the such a large beam size. Thus we should develop such tool.

Functions

Measuring the spatial distribution of intensities of a laser beam.

Locations

Anywhere in the initial alignment phase.

Requirements

TBD

Characteristics

TBD. The larger ones and middle one should be newly developed. There are some commercial products for smaller ones.

Inspection plans

TBD

Procurement process and plans

TBD

LCGT/subgroup/AOS/BeamModeProfiler1 (last edited 2012-09-16 20:37:26 by KiwamuIzumi)