|
Size: 613
Comment:
|
Size: 1327
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 1: | Line 1: |
| = Optical Lever = | = Optical Lever (Room Temperature) = |
| Line 7: | Line 7: |
| Optical lever for LCGT-SAS system | Sensing local motions including longitudinal dof and all alignment dofs (pitch, yaw and roll) of any mirrors supported by vibration isolation system. <!> Operating temperature: here the system is assumed to be utilized at room temperature, not in cryogenic temperature. |
| Line 10: | Line 14: |
| * Spec. for vacuum chambers * Any... |
|
| Line 23: | Line 25: |
| * | * ITM chambers (X,Y) * ETM chambers (X,Y) * PRC chambers (dummyPRC, PR2, PR3) * SRC chambers (dummySRC, SR2, SR3) * MC chambers (MC1, MC2...) |
| Line 26: | Line 32: |
| TBD | * Sensor noise should be less than xxx. * Sensor's dynamic range should be greater than xxx. * At least horizontal degrees of freedom (X,Y) * Preferably a vertical sensor (Z) and side * The sensors have to be rigidly mounted on the ground so that these are useful for remembering the position of the mirror and recording the drifts. |
| Line 35: | Line 45: |
| == Procurement process and plans == TBD |
|
| Line 36: | Line 49: |
| * [[https://dcc.ligo.org/cgi-bin/DocDB/ShowDocument?docid=29666&version=1|LIGO-T1000746-v1, Viewports Subsystem Final Design Document]] | * [[http://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=418|JGW-G1100418]] |
Optical Lever (Room Temperature)
Related subgroups: VIS, IOO, MIF, VAC, CRY...
Contents
Scope
Sensing local motions including longitudinal dof and all alignment dofs (pitch, yaw and roll) of any mirrors supported by vibration isolation system.
Operating temperature: here the system is assumed to be utilized at room temperature, not in cryogenic temperature.
Applicable Documents
General Description
Receiver and Transmitter
Naming Conventions
TBD
Locations
- BS chamber
- ITM chambers (X,Y)
- ETM chambers (X,Y)
- PRC chambers (dummyPRC, PR2, PR3)
- SRC chambers (dummySRC, SR2, SR3)
- MC chambers (MC1, MC2...)
Requirements
- Sensor noise should be less than xxx.
- Sensor's dynamic range should be greater than xxx.
- At least horizontal degrees of freedom (X,Y)
- Preferably a vertical sensor (Z) and side
- The sensors have to be rigidly mounted on the ground so that these are useful for remembering the position of the mirror and recording the drifts.
Characteristics
TBD
Inspection plans
TBD
Procurement process and plans
TBD