= 20180131 =
[[http://klog.icrr.u-tokyo.ac.jp/osl/?r=4070]]
== Today's activities ==
Workers: Akutsu, Simon, Miyo, Hasegawa, T. Yamamoto with helps by Miyamoto
 * Continued cabling outside of the clean booth (Yamamoto, Miyo, Simon)
 * Installed an oplev viewport in the -X-Y direction (Hasegawa)
 * Practiced to connect a burndy receptacle terminal to an electric wire AWG36 (Akutsu); in the afternoon Miyamoto showed us his well-trained technique. Thanks!
 * With all above, connected a thermometer in the cryostat to a cryocon outside of the clean booth; now the temperature can be read from the cryocon even via network!
  * Miyo just tried to heat up the thermometer by his temperature and it worked (?).
 * Installed the digital system; connected an oplev in the booth, and now the signal can be read via the digital system.
  * Note that the pylons are still not rigidly fixed on the floor; don't forget it.
 * '''[Ongoing]''' Need cares of water springs from anchor bolts for oplev pylons.
 * '''[Ongoing]''' Need to confirm what are the scratch lines made by the measurement by the KEK team last week.

== Next plan ==
 * Set up thermometers; especially their pins.
 * Set up oplev to check how the damping would be now after the replacement of the damping magnets.
 * Check the reproducibility of the alignment of the suspension among several modes.  
 * Prepare calibration of photosensors.
 * Connect burndy pins to the heaters??
 * Check heights of several points.
 * Wash the coil in ethanol at Univ. of Toyama...?
 * Take care of water spring??


== Wanted! ==
 * A tweezer.
 * An ND filter for the oplev beam.
 * '''''Stages outside the chamber''''' to ease wiping our legs.
 * Good '''''rail(?)''''' to move the WAB suspension in the cryostat in the main beam direction.
 * '''''Chain block?''''' to support the load in the chamber.
 * Cutters and scissors!!
 * A clock to know the time easily.
 * A fiber cleaner to connect oplev source parts; '''''need to get back''''' from Yend.
 * M6 screw set.