= 20180220 =
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=4231]]
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=4232]]
 * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=4233]]

== Today's activities ==
Workers: Simon, Miyo, Akutsu
 * Continued to calibrate the photosensors; see [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=4231|here]].
  * '''''Potential issue''''': About PS-2 in the above link, PDs were got unexpected voltage and currents (1.5V, 60mA according to Miyo-kun; meaing 30mA tp each PD). Not sure this could be related to the different shape of the calibration factor measurement. No idea.
 * '''[Ongoing]''' Need cares of water springs from anchor bolts for oplev pylons.
 * '''[Ongoing]''' Need to confirm what are the scratch lines made by the measurement by the KEK team last week.

== Next plan ==
 * Calibrate the PS.
 * Connect heat links and the heat link anchor block.
 * Complete the calibration of the oplev; the arm length was reported by Simon, so....
 * Check the balance of the suspended WAB with some wires and sensors are attached.
 * Check how the damping would be now after the replacement of the damping magnets.
 * Check the reproducibility of the alignment of the suspension among several modes.  
 * Check heights of several points.
 * Take care of water spring??

== Wanted! ==
 * Two burndy connectors, vacuum compatible.
 * '''''Stages outside the chamber''''' to ease wiping our legs.
 * Good '''''rail(?)''''' to move the WAB suspension in the cryostat in the main beam direction.
 * '''''Chain block?''''' to support the load in the chamber.
 * A clock to know the time easily.
 * M6 screw set.